Abstract:A single-phase grounding fault often occurs in 10 kV distribution networks, seriously affecting the safety of equipment and personnel. With the popularization of urban cables, the low-resistance grounding system gradually replaced arc suppression coils in some large cities. Compared to arc suppression coils, the low-resistance grounding system features simplicity and reliability. However, when a high-resistance grounding fault occurs, a lower amount of fault characteristics cannot trigger the zero-sequence protection action, so this type of fault will exist for a long time, which poses a threat to the power grid. To address this kind of problem, in this paper, a hybrid grounding system combining the low-resistance protection device and fully controlled power module is proposed. During a low-resistance grounding fault, the fault isolation is achieved through the zero-sequence current protection with the low-resistance grounding system itself, while, during a high-resistance grounding fault, the reliable arc extinction is achieved by regulating the neutral-point voltage with a fully controlled power module. Firstly, this paper introduces the principles, topology, and coordination control of the hybrid grounding system for active voltage arc extinction. Subsequently, a dual-loop-based control method is proposed to suppress the fault phase voltage. Furthermore, a faulty feeder selection method based on the Kepler optimization algorithm and convolutional neural network is proposed for the timely removal of permanent faults. Lastly, the simulation and HIL-based emulated results verify the rationality and effectiveness of the proposed method.

Research of Neutral Grounding Modes for 20 Kv Distribution Network

Research of neutral grounding modes for 20kV distribution network

Research on Neutral Point Grounding via Resistance for 66 kV Distribution Network

Discussion of Neutral Point Grounding Mode for AC Low Voltage Distribution System

Discussion about 20 kV System Client Substation Design

Neutral-Point Voltage Regulation and Control Strategy for Hybrid Grounding System Combining Power Module and Low Resistance in 10 kV Distribution Network

An Active Voltage-Type Grounding Fault Protection Method for Medium-Voltage Distribution Networks with Neutral Point Voltage Flexible Regulation

Impact of zero-sequence mutual inductance in UHV Anhui-to-east power transfer lines on phase-earth distance protection

Interval Analysis about Influence on Reliability of Power Distribution Lines with Various Grounded Neutrals

Research on setting calculation of zero sequence directional overcurrent protection for 110 kV neutral point grounding via resistance system

Analysis and Detection of High Impedance Grounding Fault in Neutral Point Effectively Grounding Distribution Network

Research on Grounding Mode of Zhoushan Multi-Terminal Flexible DC Transmission System

Study on High Impedance Grounding Fault Protection for Personal Safety Guard in Distribution Grid

Grounding Methods of Multi-Terminal VSC-HVDC System Based on Modular Multi-level Converter

Research on Hangzhou 10 Kv Distribution Network Closing Loop Operation

Lightning Disturbance Analysis and Improvement Measures for “Generation-Grid-Load-Storage” Type Distribution Line

Analysis of Fault Characteristics of Distribution Network with PST Loop Closing Device under Small Current Grounding System

Analysis of Application of 500 kV Transformer with Low Reactance Grounding

Measures to Restrain the Neutral Current of the AC Transformer in HVDC Ground Return System

Decision Arithmetic of Neutral Groundin G Mode Based on Interval Multi-attribute Weighted Grey Target Theory

Study on Neutral-Bus Overvoltage Mechanism of ±500 Kv DC Power Transmission Project from Tianshengqiao to Guangdong