Abstract:A single-phase grounding fault often occurs in 10 kV distribution networks, seriously affecting the safety of equipment and personnel. With the popularization of urban cables, the low-resistance grounding system gradually replaced arc suppression coils in some large cities. Compared to arc suppression coils, the low-resistance grounding system features simplicity and reliability. However, when a high-resistance grounding fault occurs, a lower amount of fault characteristics cannot trigger the zero-sequence protection action, so this type of fault will exist for a long time, which poses a threat to the power grid. To address this kind of problem, in this paper, a hybrid grounding system combining the low-resistance protection device and fully controlled power module is proposed. During a low-resistance grounding fault, the fault isolation is achieved through the zero-sequence current protection with the low-resistance grounding system itself, while, during a high-resistance grounding fault, the reliable arc extinction is achieved by regulating the neutral-point voltage with a fully controlled power module. Firstly, this paper introduces the principles, topology, and coordination control of the hybrid grounding system for active voltage arc extinction. Subsequently, a dual-loop-based control method is proposed to suppress the fault phase voltage. Furthermore, a faulty feeder selection method based on the Kepler optimization algorithm and convolutional neural network is proposed for the timely removal of permanent faults. Lastly, the simulation and HIL-based emulated results verify the rationality and effectiveness of the proposed method.

Research on Neutral Point Grounding via Resistance for 66 kV Distribution Network

Research of neutral grounding modes for 20kV distribution network

Research of Neutral Grounding Modes for 20 Kv Distribution Network

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

Neutral-Point Voltage Regulation and Control Strategy for Hybrid Grounding System Combining Power Module and Low Resistance in 10 kV Distribution Network

Research on setting calculation of zero sequence directional overcurrent protection for 110 kV neutral point grounding via resistance system

An Active Voltage-Type Grounding Fault Protection Method for Medium-Voltage Distribution Networks with Neutral Point Voltage Flexible Regulation

Grounding System Analysis of 220 Kv Power Cable Lines Installed Underneath a Bridge

Study on Neutral-Point Voltage Balance of 3-Level NPC Inverter in 3-Phase 4-Wire System

Reliability-Enhanced Hybrid Grounding System Based on Active Neutral-Point Voltage Regulator and Low-Resistance

Study on High Impedance Grounding Fault Protection for Personal Safety Guard in Distribution Grid

Analysis and Detection of High Impedance Grounding Fault in Neutral Point Effectively Grounding Distribution Network

Study on simulation of ferroresonance elimination in 10kV power system

Research And Design Of The Neutral Series Resistor To Restrain The Hvdc Ground Current Flowing Into Transformer

Discussion about 20 kV System Client Substation Design

Study on Neutral-Bus Overvoltage Mechanism of ±500 Kv DC Power Transmission Project from Tianshengqiao to Guangdong

Experimental Research on Typical Single-Phase High Resistance Grounding Fault Detection Methods in Resonant Grounding Distribution System

Fault Analysis of Neutral Point Ungrounded System Single-phase not Fully Grounded

Flexible Grounding System for Single-Phase to Ground Faults in Distribution Networks: A Systematic Review of Developments

Three‐phase four‐wire power flow solution for multi‐grounded distribution networks with non‐bolted grounding

Grounding System Design Method in High Soil Resistivity Regions