Abstract:One of the challenges for improving the performance and cost-effectiveness of solid oxide fuel cells (SOFCs) is the development of effective interconnect materials. A widely used interconnect ceramic for SOFCs is doped lanthanum chromite. In this paper, we report a doped lanthanum chromite, La0.7Ca0.3CrO3−δ (LCC)+xwt.% Gd0.2Ce0.8O1.9 (GDC) (x=0–10), with improved electrical conductivity and sintering capability. In this composite material system, LCC+GDC were prepared by an auto-ignition process and the electrical conductivity was characterized in air and in H2. The LCC powders exhibited a better sintering ability and could reach a 94.7% relative density at 1400°C for 4h in air and with the increase of GDC content the relative density increased, reached 98.5% when the GDC content was up to 10wt.%. The electrical conductivity of the samples dramatically increased with GDC addition until a maximum of 134.48Scm−1 in air at 900°C when the materials contained 3wt.% GDC. This is 5.5 times higher than pure LCC (24.63Scm−1). For the sample with a 1wt.% GDC content, the conductivity in pure H2 at 900°C was a maximum 5.45Scm−1, which is also higher than that of pure LCC ceramics (4.72Scm−1). The average thermal expansion coefficient (TEC) increased with the increase of GDC content, ranging from 11.12 to 14.32×10−6K−1, the majority of which unfortunately did not match that of 8YSZ. The oxygen permeation measurement presented a negligible oxygen ionic conduction, indicating that it is still an electronically conducting ceramic. Therefore, it is a very promising interconnect material for higher performance and cost-effectiveness for SOFCs.

Low temperature sintering ability and electrical conductivity of SOFC interconnect material La0.7Ca0.3Cr0.97O3

Low-temperature Solid Oxide Fuel Cells with Novel La0.6Sr0.4Co0.8Cu0.2O3−δ Perovskite Cathode and Functional Graded Anode

Influence of Cr deficiency on sintering, thermal expansion and electrical properties of La0.75Sr0.25Cr1−xO3−δ as a SOFC interconnect material

Influence of Cr Deficiency on Sintering Character and Properties of SOFC Interconnect Material La0.7Ca0.3Cr1−xO3−δ

High sintering ability and electrical conductivity of Zn doped La(Ca)CrO3 based interconnect ceramics for SOFCs

Influence of CeO2-doping on Low-temperature Sintering Ability and Electrical Conductivity of La0.7Ca0.3CrO3-δ

Short communicationHigh sintering ability and electrical conductivity of Zn doped La(Ca)CrO3 based interconnect ceramics for SOFCs

Microwave assisted synthesis,sinterability and properties of Ca-Zn co-doped LaCrO_3 as interconnect material for IT-SOFCs

Study on Synthesis by Microwave-aided Sol-gel Process and Sintering Abilities of La_(0.7)Ca_(0.3)CrO_(3-δ) Fine Powders

Synthesis and Low-temperature Sintering of Y0.8 Sr0.2 CrO3-δ Ultrafine Powder

Electrical Properties, Sintering and Thermal Expansion Behavior of Composite Ceramic Interconnecting Materials, La0.7Ca0.3CrO3−δ/Y0.2Ce0.8O1.9 for SOFCs

A Novel Interconnect Material for Sofcs

A High Performance Interconnecting Ceramics for Solid Oxide Fuel Cells (Sofcs)

Influence of Zn-doping on low-temperature sintering ability and electrical conductivity of YCrO3-based ceramic interconnect materials

Evaluation of simple, easily sintered La0.7Ca0.3Cr0.97 O3-δ perovskite oxide as novel interconnect material for solid oxide fuel cells

Preparation and properties of ceramic interconnecting materials, La0.7Ca0.3CrO3-δ doped with GDC for IT-SOFCs

Preparation and Electrical Behavior Study of the Ceramic Interconnect La0.7Ca0.3CrO3−δ with CeO2-based Electrolyte Ce0.8Sm0.2O1.9

Preparation and Electrical Properties of Interconnect Material Made by Substituting Mixed Rare Earth Oxides (Sm<sub>2</sub>O<sub>3</sub>, Gd<sub>2</sub>O<sub>3</sub>, Eu<sub>2</sub>O<sub>3</sub> and CeO<sub>2</sub>) for La<sub>2</sub>O<sub>3</sub> in La

Synthesis and Electrical Conductivity of Perovskite Gd1−xCaxCrO3 (0⩽x⩽0.3) by Auto-Ignition Process

Preparation And Electrical Properties Of Interconnect Material Made By Substituting Mixed Rare Earth Oxides (Sm2o3, Gd2o3, Eu2o3 And Ceo2) For La2o3 In La1-Xcaxcro3 (0.1 <= X <= 0.4)

Synthesis and electrical conductivity of perovskite Gd1-xCa xCrO3 (0≤x≤0.4) by ignition process