Abstract:One of the challenges for improving the performance and cost-effectiveness of solid oxide fuel cells (SOFCs) is the development of effective interconnect materials. A widely used interconnect ceramic for SOFCs is doped lanthanum chromite. In this paper, we report a doped lanthanum chromite, La0.7Ca0.3CrO3−δ (LCC)+xwt.% Gd0.2Ce0.8O1.9 (GDC) (x=0–10), with improved electrical conductivity and sintering capability. In this composite material system, LCC+GDC were prepared by an auto-ignition process and the electrical conductivity was characterized in air and in H2. The LCC powders exhibited a better sintering ability and could reach a 94.7% relative density at 1400°C for 4h in air and with the increase of GDC content the relative density increased, reached 98.5% when the GDC content was up to 10wt.%. The electrical conductivity of the samples dramatically increased with GDC addition until a maximum of 134.48Scm−1 in air at 900°C when the materials contained 3wt.% GDC. This is 5.5 times higher than pure LCC (24.63Scm−1). For the sample with a 1wt.% GDC content, the conductivity in pure H2 at 900°C was a maximum 5.45Scm−1, which is also higher than that of pure LCC ceramics (4.72Scm−1). The average thermal expansion coefficient (TEC) increased with the increase of GDC content, ranging from 11.12 to 14.32×10−6K−1, the majority of which unfortunately did not match that of 8YSZ. The oxygen permeation measurement presented a negligible oxygen ionic conduction, indicating that it is still an electronically conducting ceramic. Therefore, it is a very promising interconnect material for higher performance and cost-effectiveness for SOFCs.

Influence of Cr deficiency on sintering, thermal expansion and electrical properties of La0.75Sr0.25Cr1−xO3−δ as a SOFC interconnect material

Influence of Cr Deficiency on Sintering Character and Properties of SOFC Interconnect Material La0.7Ca0.3Cr1−xO3−δ

Low temperature sintering ability and electrical conductivity of SOFC interconnect material La0.7Ca0.3Cr0.97O3

High sintering ability and electrical conductivity of Zn doped La(Ca)CrO3 based interconnect ceramics for SOFCs

Microwave assisted synthesis,sinterability and properties of Ca-Zn co-doped LaCrO_3 as interconnect material for IT-SOFCs

Evaluation of simple, easily sintered La0.7Ca0.3Cr0.97 O3-δ perovskite oxide as novel interconnect material for solid oxide fuel cells

Preparation and properties of ceramic interconnecting materials, La0.7Ca0.3CrO3-δ doped with GDC for IT-SOFCs

Evaluation of A-site deficient Sr1−xSc0.175Nb0.025Co0.8O3−δ (x=0, 0.02, 0.05 and 0.1) perovskite cathodes for intermediate-temperature solid oxide fuel cells

Study on Synthesis by Microwave-aided Sol-gel Process and Sintering Abilities of La_(0.7)Ca_(0.3)CrO_(3-δ) Fine Powders

A High Performance Interconnecting Ceramics for Solid Oxide Fuel Cells (Sofcs)

Electrode redox properties of Ba 1−x La x FeO 3−δ as cobalt free cathode materials for intermediate-temperature SOFCs

Synthesis and characterization of La0.75Sr0.25Mn0.5Cr0.5-x CuxO3-δ for SOFC anode material

Properties of nonstoichiometric Pr0.6-xSr0.4MnO3 as the cathodes of SOFCs

Characterization of A-site Excessive Perovskite La0.7–xSmx+0.02Ca0.3CrO3–δ

Synthesis And Characterization Of La0.75sr0.25mn0.5cr0.5-Xcuxo3-Delta For Sofc Anode Material

Sr-deficient medium-entropy Sr1-xCo0.5Fe0.2Ti0.1Ta0.1Nb0.1O3-δ cathodes with high Cr tolerance for solid oxide fuel cells

Tuning Cu-Content La1−xSrxNi1−yCuyO3−δ with Strontium Doping as Cobalt-Free Cathode Materials for High-Performance Anode-Supported IT-SOFCs

Study on the Conductivity of La0.4Sr1.6CoNbO6-δ as an Electrode Material for Symmetrical SOFC

Synthesis and electrical conductivity of perovskite Gd1-xCa xCrO3 (0≤x≤0.4) by ignition process

Effects of La doping on electrical conductivity, thermal expansion and electrochemical performance in LaxSr1–xCo0.9Sb0.1O3–δ cathodes for IT–SOFCs

Preparation and Properties of Cathode Materials for SOFC