Abstract:One of the challenges for improving the performance and cost-effectiveness of solid oxide fuel cells (SOFCs) is the development of effective interconnect materials. A widely used interconnect ceramic for SOFCs is doped lanthanum chromite. In this paper, we report a doped lanthanum chromite, La0.7Ca0.3CrO3−δ (LCC)+xwt.% Gd0.2Ce0.8O1.9 (GDC) (x=0–10), with improved electrical conductivity and sintering capability. In this composite material system, LCC+GDC were prepared by an auto-ignition process and the electrical conductivity was characterized in air and in H2. The LCC powders exhibited a better sintering ability and could reach a 94.7% relative density at 1400°C for 4h in air and with the increase of GDC content the relative density increased, reached 98.5% when the GDC content was up to 10wt.%. The electrical conductivity of the samples dramatically increased with GDC addition until a maximum of 134.48Scm−1 in air at 900°C when the materials contained 3wt.% GDC. This is 5.5 times higher than pure LCC (24.63Scm−1). For the sample with a 1wt.% GDC content, the conductivity in pure H2 at 900°C was a maximum 5.45Scm−1, which is also higher than that of pure LCC ceramics (4.72Scm−1). The average thermal expansion coefficient (TEC) increased with the increase of GDC content, ranging from 11.12 to 14.32×10−6K−1, the majority of which unfortunately did not match that of 8YSZ. The oxygen permeation measurement presented a negligible oxygen ionic conduction, indicating that it is still an electronically conducting ceramic. Therefore, it is a very promising interconnect material for higher performance and cost-effectiveness for SOFCs.

Synthesis and electrical conductivity of perovskite Gd1-xCa xCrO3 (0≤x≤0.4) by ignition process

Synthesis and Electrical Conductivity of Perovskite Gd1−xCaxCrO3 (0⩽x⩽0.3) by Auto-Ignition Process

Preparation And Electrical Properties Of Interconnect Material Made By Substituting Mixed Rare Earth Oxides (Sm2o3, Gd2o3, Eu2o3 And Ceo2) For La2o3 In La1-Xcaxcro3 (0.1 <= X <= 0.4)

Preparation and Electrical Properties of Interconnect Material Made by Substituting Mixed Rare Earth Oxides (Sm<sub>2</sub>O<sub>3</sub>, Gd<sub>2</sub>O<sub>3</sub>, Eu<sub>2</sub>O<sub>3</sub> and CeO<sub>2</sub>) for La<sub>2</sub>O<sub>3</sub> in La

Preparation and Electrical Properties of Interconnect Material Made by Substituting Mixed Rare Earth Oxides (Sm<sub>2</sub>O<sub>3</sub>, Gd<sub>2</sub>O<sub>3</sub>, Eu<sub>2</sub>O<sub>3</sub> and CeO<sub>2</sub>) for La<sub>2</sub>O<sub>3</sub> in La

Influence of Cr deficiency on sintering, thermal expansion and electrical properties of La0.75Sr0.25Cr1−xO3−δ as a SOFC interconnect material

Preparation and properties of ceramic interconnecting materials, La0.7Ca0.3CrO3-δ doped with GDC for IT-SOFCs

Structure, electrical and thermal properties of (Ba 0.5Sr 0.5) 1 - XGd xCo 0.8Fe 0.2O 3-δ perovskite as a solid-oxide fuel cell cathode

Low temperature sintering ability and electrical conductivity of SOFC interconnect material La0.7Ca0.3Cr0.97O3

PREPARATION AND CHARACTERIZATION OF Gd_(1-x)Sr_xCoO_(3-δ) AS INTERMEDIATE TEMPERATURE SOLID OXIDE FUEL CELL CATHODE MATERIAL

Study on Synthesis by Microwave-aided Sol-gel Process and Sintering Abilities of La_(0.7)Ca_(0.3)CrO_(3-δ) Fine Powders

Preparation and Electrical Behavior Study of the Ceramic Interconnect La0.7Ca0.3CrO3−δ with CeO2-based Electrolyte Ce0.8Sm0.2O1.9

Preparation And Characterization Of Ba0.4sr0.6co1-Xfexo3-Delta Cathode Materials

Evaluation of A-site deficient Sr1−xSc0.175Nb0.025Co0.8O3−δ (x=0, 0.02, 0.05 and 0.1) perovskite cathodes for intermediate-temperature solid oxide fuel cells

Characterization of A-site Excessive Perovskite La0.7–xSmx+0.02Ca0.3CrO3–δ

Preparation and characterization of Gd1-xSrxCoO 3-δ and Gd0.8Sr0.2Co1-yFe yO3-δ

Synergistic electron doping and ion conductive phase incorporating of SrCoO3- as desirable cathode materials for intermediate-temperature solid oxide fuel cells

Study on synthesis of Pr1-xCaxCrO3 and their electrical properties

A High Performance Interconnecting Ceramics for Solid Oxide Fuel Cells (Sofcs)

Stable, Easily Sintered Ca–Zn-doped YCrO3 As Novel Interconnect Materials for Co-Fired Yttrium-Stabilized Zirconia-Based Solid Oxide Fuel Cells

Perovskite Sr1-Xcexcoo3-Delta (0.05 <= X <= 0.15) As Superior Cathodes for Intermediate Temperature Solid Oxide Fuel Cells