Abstract:One of the challenges for improving the performance and cost-effectiveness of solid oxide fuel cells (SOFCs) is the development of effective interconnect materials. A widely used interconnect ceramic for SOFCs is doped lanthanum chromite. In this paper, we report a doped lanthanum chromite, La0.7Ca0.3CrO3−δ (LCC)+xwt.% Gd0.2Ce0.8O1.9 (GDC) (x=0–10), with improved electrical conductivity and sintering capability. In this composite material system, LCC+GDC were prepared by an auto-ignition process and the electrical conductivity was characterized in air and in H2. The LCC powders exhibited a better sintering ability and could reach a 94.7% relative density at 1400°C for 4h in air and with the increase of GDC content the relative density increased, reached 98.5% when the GDC content was up to 10wt.%. The electrical conductivity of the samples dramatically increased with GDC addition until a maximum of 134.48Scm−1 in air at 900°C when the materials contained 3wt.% GDC. This is 5.5 times higher than pure LCC (24.63Scm−1). For the sample with a 1wt.% GDC content, the conductivity in pure H2 at 900°C was a maximum 5.45Scm−1, which is also higher than that of pure LCC ceramics (4.72Scm−1). The average thermal expansion coefficient (TEC) increased with the increase of GDC content, ranging from 11.12 to 14.32×10−6K−1, the majority of which unfortunately did not match that of 8YSZ. The oxygen permeation measurement presented a negligible oxygen ionic conduction, indicating that it is still an electronically conducting ceramic. Therefore, it is a very promising interconnect material for higher performance and cost-effectiveness for SOFCs.

Fabrication of dense La 0.7Ca 0.3 Cr 0.97O 3-δ interconnect membrane on novel SOFC composite support by co-firing

Fabrication of Dense La0.7Ca0.3Cr0.97O3-δ Interconnect Thin Membrane on Composite Anode Support by Co-firing

Fabrication of Dense La0.7Ca0.3Cr0.97O3-delta Interconnect Thin Membrane on Composite Anode Support by Co-firing

Fabrication of Dense LaCrO3-based Interconnect Thin Membrane on Anode Substrates by Co-Firing

Evaluation of simple, easily sintered La0.7Ca0.3Cr0.97 O3-δ perovskite oxide as novel interconnect material for solid oxide fuel cells

Preparation and properties of ceramic interconnecting materials, La0.7Ca0.3CrO3-δ doped with GDC for IT-SOFCs

Electrical Properties, Sintering and Thermal Expansion Behavior of Composite Ceramic Interconnecting Materials, La0.7Ca0.3CrO3−δ/Y0.2Ce0.8O1.9 for SOFCs

High Performance LaCo0.6Ni0.4O3-δ Cathode Contact Material for Intermediate Temperature Solid Oxide Fuel Cells

Influence of Cr deficiency on sintering, thermal expansion and electrical properties of La0.75Sr0.25Cr1−xO3−δ as a SOFC interconnect material

High sintering ability and electrical conductivity of Zn doped La(Ca)CrO3 based interconnect ceramics for SOFCs

Microwave assisted synthesis,sinterability and properties of Ca-Zn co-doped LaCrO_3 as interconnect material for IT-SOFCs

A High Performance Interconnecting Ceramics for Solid Oxide Fuel Cells (Sofcs)

High Performance LaCo<sub>0.6</sub>Ni<sub>0.4</sub>O<sub>3-</sub><sub>δ</sub> Cathode Contact Material for Intermediate Temperature Solid Oxide Fuel Cells

Improved Electrochemical Performance of NiO–La0.45Ce0.55O2−δ Composite Anodes for IT-SOFC Through the Introduction of a La0.45Ce0.55O2−δ Interlayer

A Novel Interconnect Material for Sofcs

Short communicationHigh sintering ability and electrical conductivity of Zn doped La(Ca)CrO3 based interconnect ceramics for SOFCs

Conducting Property and Performance Evaluation of LNF As Cathode Current Contact Layer in Solid Oxide Fuel Cell

LaCo0.6Ni0.4O3-δ as cathode contact material for intermediate temperature solid oxide fuel cells

Design and Conductivity Optimization of La0.3Sr0.7TiO3/La0.8Sr0.2MnO3 Bi-Layer Structures As Tubular Segmented-in-series Solid Oxide Fuel Cell Interconnect☆

Validation and Electrochemical Characterization of LSCF Cathode Deposition on Metal Supported SOFC

Stable and Easily Sintered (pr0.5nd0.5)0.7ca0.3cro3−δ/sm0.2ce0.8o1.9 Composite Interconnect Materials for IT-solid Oxide Fuel Cells