Abstract:Reaction-bonded Si3N4 composites reinforced by whisker-like SiC rod particulates have been fabricated by nitriding SiCrod-containing Si powder compacts, which were presintered to a controlled density by spark plasma sintering (SPS). The effects of processing parameters, including presintered density, SiCrod content, nitriding temperature, atmosphere pressure and heating rate on the nitridation reaction were investigated. It was found that the addition of SiCrod to Si powders led to easier control of complete nitridation compared to the case of pure Si powder compacts, probably because the SiCrod not only acted as diluting filler to suppress the rapid rise in temperature resulting from an SHS-like reaction between Si and N2, but also provided paths for diffusion of reactant gases. The density of the reaction-bonded Si3N4–50 vol% SiCrod composites was increased up to near 90% which is quite a lot higher than that of conventional reaction-bonded Si3N4 ceramics, by using SPS to improve the density prior to nitridation. The relative density increased from ∼70 to 90% after the nitridation without appreciable dimensional change, being characteristic of reaction-sintering. As the reinforcement in the reaction products, the SiCrod improved Young's modulus and bending strength both at ambient and elevated temperatures, as well as thermal and electric conductivity.

Preparation of the Rod-Like Β-Si3n4 Particles Favoring the Self-Reinforcing Si3N4 Ceramics

Preparation of the rod-like {beta}-Si{sub 3}N{sub 4} particles favoring the self-reinforcing Si{sub 3}N{sub 4} ceramics

Preparation of β-Si3N4 Seeds and Self-reinforced Si3N4 Ceramics

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

New Route to Improve the Fracture Toughness and Flexural Strength of Si3N4 Ceramics by Adding FeSi2

Preparation of β-Si3N4 Single Crystal Particles

Preparation and Characterization of Rod-Like Β-Si<sub>3</sub>n<sub>4</sub> Seeds

Effect of the Residual Phases in Β-Si3n4 Seed on the Mechanical Properties of Self-Reinforced Si3N4 Ceramics

Microstructure and Performance of Silicon Nitride Ceramics with Lu2O3 Additives

Study on the Preparation,Properties and Mechnism of β-Si_3N_4 Crystal Seeds

Fabrication and Characterization of β-Si3N4 Seeds with Additive of Lu2O3

Influence of α-Si3N4 coarse powder on densification, microstructure, mechanical properties, and thermal behavior of silicon nitride ceramics

Synthesis of Fibrous Β-Si3n4 Structured Porous Ceramics Using Carbothermal Nitridation of Silica

The Effects of the Single Additive on the Fabrication of Rod-like β-Si3N4

Mechanical Property and Oxidation Behavior of Self-Reinforced Si3N4 Doped with Re2O3 (Re=Yb, Lu)

The effects of the single additive on the fabrication of rod-like beta-Si3N4

Effect of Initial Phase Composition on the Phase Composition, Microstructure, and Mechanical Properties of Si3N4 Ceramics

Fabrication of high performance silicon nitride ceramics with TiO2 additive by annealing process

Influence of Yttria–Alumina Content on Sintering Behavior and Microstructure of Silicon Nitride Ceramics

Fabrication and Characterization of Sic Rod-Particulate-Reinforced Reaction-Bonded Si3n4 Composites

Effects of Β-Si3n4 Seeds Addition on Microstructure and Mechanical Properties of Porous Si3N4 Ceramics