Field Test and Numerical Simulation for Co-combustion of Sludge in a 100,MW Coal Fired Boiler
Cheng Zhang,Tianyu Zhu,Libao Yin,Qingyan Fang,Zhigang Zhan,Qisheng Xu,Gang Chen
DOI: https://doi.org/10.11715/rskxjs.R201408029
2015-01-01
Abstract:Field test and numerical simulation were carried out to evaluate the characteristics of co-combustion coal and sludge in a 100,MW tangentially fired utility boiler,and the characteristics of flow,combustion and NOx emis-sions were studied. The simulation results were consistent with the experimental data when the sludge moisture con-tent was 56% and the blending mass fraction of sluage was less than 10%.The furnace temperature of co-combustion was lower than that of coal combustion,the total burnout rate fell,and the fly ash carbon content and NOx emissions increased,but the differences were small,which indicate that co-combustion with low mass fraction of sludge had little effect on the boiler. Further researches were conducted to study the influence of moisture content and high blend-ing mass fraction of sludge on combustion characteristics and NOx emissions. Results show that the decrease of sludge moisture content with the same blending mass fraction was helpful to improve the boiler combustion characteristics, although NOx emissions increased a little;Increasing the blending mass fraction of sludge but keeping it lower than 20% had little influence on combustion characteristics and NOx emissions of the boiler;but when the blending mass fraction of sludge was greater than 20%,sludge combustion characteristics significantly influenced mixed-fuel prop-erties,the firing effect of the boiler went worse,and NOx emissions increased by a large scale,which indicatethat when the boiler combined firing with high blending mass fraction of sludge(over 20%),some measures shouldbe taken to control the firing effect and NOx emissions. Increasing over fire air ratio or decreasing the total second air could reduce NOx emissions. More attention should be paid to slag-bonding in the furnace in practice.