Abstract:Field test and numerical simulation were carried out to evaluate the characteristics of co-combustion coal and sludge in a 100,MW tangentially fired utility boiler,and the characteristics of flow,combustion and NOx emis-sions were studied. The simulation results were consistent with the experimental data when the sludge moisture con-tent was 56% and the blending mass fraction of sluage was less than 10%.The furnace temperature of co-combustion was lower than that of coal combustion,the total burnout rate fell,and the fly ash carbon content and NOx emissions increased,but the differences were small,which indicate that co-combustion with low mass fraction of sludge had little effect on the boiler. Further researches were conducted to study the influence of moisture content and high blend-ing mass fraction of sludge on combustion characteristics and NOx emissions. Results show that the decrease of sludge moisture content with the same blending mass fraction was helpful to improve the boiler combustion characteristics, although NOx emissions increased a little;Increasing the blending mass fraction of sludge but keeping it lower than 20% had little influence on combustion characteristics and NOx emissions of the boiler;but when the blending mass fraction of sludge was greater than 20%,sludge combustion characteristics significantly influenced mixed-fuel prop-erties,the firing effect of the boiler went worse,and NOx emissions increased by a large scale,which indicatethat when the boiler combined firing with high blending mass fraction of sludge(over 20%),some measures shouldbe taken to control the firing effect and NOx emissions. Increasing over fire air ratio or decreasing the total second air could reduce NOx emissions. More attention should be paid to slag-bonding in the furnace in practice.

Experiment on Slag Bonding of Boiler in Power Station and Optimization of Coal

Experiment research of anthracite coal mixed burning in boiler

Impact of Coal Types and Pulverizing Methods on the Thermal Performance of Blending Coal-Fired Boilers and Their Operational Optimization

Experimental Investigation of the Scaling-Off Location and the Slag Mass in Pulverized Coal-Fired Boiler with Water-Cooled Slag Removal

PREDICTION OF BURNING BEHAVIOR FOR PULVERIZED COAL AND ITS APPLICATION ON PRACTICAL BOILERS

STUDY ON IMPROVEMENT OF BURNING BEHAVIOR FOR INDONESIAN COAL AND ITS APPLICATION ON 300 MW UNITS

Optimization adjustment of pulverizing system for a 600 MW unit boiler burning mixed inferior coal

Experimental study of sludge disposal in a large coal-fired power plant

Quantitative analysis of minerals of blended coal ash at high temperature and its influence on slagging

Theoretical and In-situ Experimental Investigation on Reducing Slagging Damage for Swirl-opposed Fired PC Boiler with Non-designed Blending Coals

Mineral Conversion of Coal-ash in Fusing Process and the Influence to Ash Fusion Point

Field Test and Numerical Simulation for Co-combustion of Sludge in a 100,MW Coal Fired Boiler

Study on the Coal Ash Fusibility During Blending Coal Combusition

Test Study Upon Slagging on the Heating Surface of Pulverized Coal Boiler

Study and Actualization of Burning Bituminous Coal in Lean Coal-fired Boiler of the 300 MW Unit

Experimental Study on Slagging Characteristic of Low-volatile Coal Water Slurry in a 220t/h Boiler

Experimental study on the comprehensive behavior of combustion for blended coals

Combustion Characteristics and Analysis of the Energy Efficiency of a Coal-fired Boiler Burning Coal Diluted and Mixed with Dried Sludge

Investigation on slagging and high-temperature corrosion prevention and control of a 1000 MW ultra supercritical double tangentially fired boiler

STUDY ON MIGRATION AND DEPOSITION BEHAVIOR OF MINERAL SUSTANCES IN COAL BURNING INSIDE THE FURNACE

Experimental Study on Factors Influencing Coproduction of Q-phase Cement Clinker by Pulverized Coal Fired Boilers