Abstract:A systematic study on the passivation quality using various poly-Si/SiOx bi-layers on c-Si is carried. We find that no any passivation effect is observed with undoped a-Si:H/SiOx and as-crystallized poly-Si/SiOx, a hydrogenation improves the passivation noticeably to reach iVoc of 733 mV. These observations imply that the chemical passivation by the undoped poly-Si/SiOx occurs only after the effective hydrogenation. The passivation with doped poly-Si/SiOx layers shows different behaviors. The n+-poly-Si already shows a reasonable good passivation with iVoc of 715 mV and 685 mV on the n-type and p-type wafers, respectively, after the crystallization without hydrogenation, and the hydrogenation improves the iVoc to 747 mV and 736 mV. The p+-poly-Si shows a poorer passivation quality than both the undoped poly-Si and n+-poly-Si, with the iVoc of 690 mV and 640 mV on the n-type and p-type c-Si wafers after the crystallization, respectively, and 707 mV and 670 mV after the hydrogenation. It concludes that the field passivation appears immediately after the crystallization, and an effective hydrogenation improves the passivation quality further. The passivation quality with the p+-poly-Si is poorer than the n+-poly-Si, which is speculatively caused by the higher interface recombination in the SiOx/c-Si region because of the higher capture cross section for electrons than holes and by additional Shockley-Read-Hall recombination through BO complex defects.

Corrosion Mechanism and Surface Passivation Strategies of Polycrystalline Silicon Electrodes

Effect of electrode geometry and surface passivation on corrosion of polycrystalline silicon under high relative humidity and bias

Etching and passivation of silicon in alkaline solution: A coupled chemical/electrochemical system

Electrochemical Reactivity and Passivation of Silicon Thin-Film Electrodes in Organic Carbonate Electrolytes

Anodic oxidation of polycrystalline 3C-silicon carbide thin films during MEMS operation

Impact of Doped Microcrystalline Silicon Oxide Layers on Crystalline Silicon Surface Passivation

Silicon Corrosion in Neutral Media: The Influence of Confined Geometries and Crevice Corrosion in Simulated Physiological Solutions

Morphological, Electrical, and Chemical Changes in Cyclically Contacting Polycrystalline Silicon Surfaces Coated with Perfluoroalkylsilane Self-Assembled Monolayer

Metallization introduced corrosion and parylene protection of surface micromachined polysilicon film with submicron capacitive gap

Single-Electrode Electrochemistry: Chemically Engineering Surface Adhesion and Hardness to Maximize Redox Work Extracted from Tribocharged Silicon

Post-Anodization Implantation and CVD Techniques for Passivation of Porous Silicon

Correlations of Electrochemical Behavior, Microstructure and Chemical Composition of Porous Silicon

Improved Corrosion Protection of Aluminum Alloys by Electrodeposited Silanes

Characterizing metallization introduced polysilicon corrosion of surface micromachined structures with submicron capacitive gap

Electrochemical Investigation of the Corrosion Properties of Three-Dimensional Nickel Electrodes on Silicon Microchannel Plates

Initial Oxidation Processes on Hydrogenated Silicon Surfaces Studied by In Situ Raman Spectroscopy

Electrochemical Behavior of Porous and Flat Silicon Electrode Interfaces

The influence of oxidizing agents on etching and passivation of silicon in KOH solution

On the passivation mechanism of poly-silicon and thin silicon oxide on crystal silicon wafers