Abstract:As the device size continues to shrink, the gate oxygen layer in MOS devices continues to become thinner, which leads to problems such as increased leakage current in conventional Si MOS devices. SiC, an important semiconductor material used in high-power devices, is not immune to the problem of premature breakdown due to the gate oxygen layer. Based on this, this paper adopts the innovative approach of replacing the conventional SiO 2 as the gate oxygen layer with the high-k material, hafnium dioxide (HfO 2 ), and continues the in-depth study on the electrical characteristics of the gate oxygen structure. In this paper, hafnium dioxide (HfO 2 ) thin films were deposited on SiC and Si substrates using the atomic layer deposition(ALD) method. The metal-insulated semiconductor (MIS) structures with Al as the upper and lower electrodes were prepared, and the leakage currents and breakdown voltage characteristics of the MOS capacitors on the two different substrates were investigated. The leakage current density of the MOS capacitor structure with SiC substrate is 10 -11 A/cm 2 ,and the breakdown voltage is about 32 V. Based on the capacitance-voltage (C-V) measurements, the frequency dependence of the movable charge at the interface of the MOS capacitor structure is investigated. The lowest interfacial defect density (D it ) of the MOS capacitive structure with SiC substrate is only of the order of 10 10 eV -1 cm -2 , while the movable charge N eff of the oxide layer of this sample is also controlled to the order of 10 13 cm -2 . It is worth mentioning that the HfO 2 /SiC structure performs better than the HfO 2 /Si structure in these electrical parameters, and the sample designed in this paper also performs better in electrical parameters than previous studies. These results undoubtedly demonstrate that the combination of High-k material (HfO 2 ) and SiC in the MOS gate oxygen layer is a promising research topic.

Characterizing metallization introduced polysilicon corrosion of surface micromachined structures with submicron capacitive gap

Metallization introduced corrosion and parylene protection of surface micromachined polysilicon film with submicron capacitive gap

The mechanical strength of polysilicon films: Part 1. The influence of fabrication governed surface conditions

Understanding the Impact of Surface Engineering, Structure, and Design on Electromigration Through Monte Carlo Simulation and In‐Situ SEM Studies

Effects of grinding-induced surface topography on the material removal mechanism of silicon chemical mechanical polishing

Porous silicon formation and electropolishing

A New Release Process for Polysilicon Surface Micromachining Using Sacrificial Polysilicon Anchor and Photolithography after Sacrificial Etching

Wafer level microarcing model in 90nm chemical-vapor deposition low-k via etch on 300mm silicon-on-insulator substrate

CMOS-Compatible Electrochemical Nanoimprint:High Throughput Fabrication of Ordered Microstructures on Semiconductor Wafer by Using a Glassy Carbon Mold

Corrosion and Microstructure Evolution of He+ Irradiated Tungsten Pfms

Study of a Mixed Conductive Layer Fabricated by Ion Implantation and Distribution Theory

Mechanisms of Silicon Surface Passivation by Negatively Charged Hafnium Oxide Thin Films

Fabrication and Characterization of Silicon on Permalloy Film

Polysilicon Passivating Contacts for Silicon Solar Cells: Interface Passivation and Carrier Transport Mechanism

Galvanic Corrosion Caused by Device Structure in Chemical Mechanical Planarization

Structural and electrical characterization of Al2O3/HfO2/Al2O3 on strained SiGe

Electrical Characterization of HfO2/4H-SiC and HfO2/Si MOS Structures

Metal-particle-induced, Highly Localized Site-Specific Etching of Si and Formation of Single-Crystalline Si Nanowires in Aqueous Fluoride Solution.

Enhancement of Electrical Properties of Nanostructured Polysilicon Layers Through Hydrogen Passivation

Corrosion and Microstructure Evolution of He+ Plasma Irradiated Tungsten PFMs

3-D finite element calculation of electric field enhancement for nanostructures fabrication mechanism on silicon surface with AFM tip induced local anodic oxidation