Abstract:The group-Ⅲ nitrides and their related ternary alloys have been becoming the most attractive material for light emitting diodes (LEDs) and laser diodes (LDs) in the UV and blue spectral range. However, the origins of the yellow luminescence (YL), which is commonly observed in almost undoped and n-type GaN, remain unclear. The nature and the role of initial nitridation of sapphire surface and the generation of threading dislocation (TD) are ambiguous too. It is a possible way to resolve the above problems by studying the microstructures and optical properties combining the growth conditions. In this work, two kinds of GaN films were grown by MOCVD under different initial nitridation time (180 seconds for Sample A, and 90s for Sample B). The growth temperature is about 950℃. The cross-sectional transmission electron microscope (TEM) is performed near the GaN/sapphire interface. Corresponding the growth processes, there are three zones in the GaN layer: buffer layer, zone and sound zone. There are haystack-like domains in the faulted zone, in which there are high density of extended defects. The thickness of the faulted zone is about 0.4μm. Just above this region, the defects density is reduced sharply, and the quality of the layer is improved, which is identified by electron diffraction (ED) patterns. In comparison, Sample A shows about an order lower density of extended defects than Sample B, their columnar diameter is larger and its ED pattern is sharper, too. The buffer layer of Sample B is more smooth than Sample A. The appropriate rougher morphology of the buffer layer may cause that the structural disorder between the high-temperature (HT) grown island and the buffer layer is accommodated by Frank and Shockley partial dislocations. However, the TD is likely to propagate into the HT GaN from the smooth surface of the buffer layer grown after extensively nitridation of substrate. According to the position and width of X-ray diffraction peaks of (0002) and (0004), the size of crystalline grain, D and the residual strain could be calculated. The values of(D,e in)of Sample A and B are (175nm,0.167%) and (90nm,0.141%), respectively. Small size of crystalline grain may be advantageous to relieve the lattice and thermal mismatch stress, but it lead to higher density of extended defects. The width of GaN (0002) reflections of Sample A is 4min lower than that of Sample B. This result may be due to the lower screw TD. The higher density of screw TD may widen the GaN (0002) peak in X-ray rocking curve. In room temperature PL spectra, the ratio of band-edge emission intensity to YL one of Sample A is 3 orders larger than that of Sample B. Furthermore the YL in Sample B is stronger and has fine structure, while that in Sample A is nearly invisible in the PL spectrum. The GaN epilayer with high quality exhibits almost no YL emission. It is well known that the YL corresponds to the deformed crystal structure. We assigned that the screw TD and mixed TD are attributed to the YL referring to our XRD results.

The Influence of As on the Optimum Nitrogen to Gallium Ratio Required to Grow High Quality Gan Films by Molecular Beam Epitaxy

The Influence of Indium Surfactant on the Electrical Properties of GaN Epilayers Grown by Metal-Organic Chemical Vapour Deposition

The Effect of Gan Single Crystal Substrate Characteristics on Homo-Epitaxial Gan Films

Influence of Growth Rate on the Carbon Contamination and Luminescence of GaN Grown on Silicon

Improvement of III-V dilute nitride thin films for solar cell application: Effect of antimony doping

Nitrogen local electronic structure in Ga(In)AsN alloys by soft-x-ray absorption and emission: Implications for optical properties

Composition and optical properties of (In,Ga)As nanowires grown by group-III-assisted molecular beam epitaxy

Study of Nitridation Effect on Structural, Morphological, and Optical Properties of GaAs Film Growth on Silicon Substrates via Close Space Vapor Transport Technique

Optimization of the Parameters for Growth High-Qulity Gan Film by Hydride Vapor Phase Epitaxy

Influence of Ga Concentration in Si Substrates on the Quality of GaN Films

Determination of effective Ga/N ratio to control GaN growth behavior in liquid-target reactive magnetron sputter epitaxy

Molecular-beam-epitaxy Growth of GaN on GaAs(100) by Using Reactive Nitrogen Source

Gan Grown on Ain/Sapphire Templates

Heteroepitaxial Growth of Cubic Gan on GaAs(100) by Reactive Nitrogen Source

Unintentional gallium incorporation in AlN and its impact on the electrical properties of GaN/AlN and GaN/AlN/AlGaN heterostructures

Origins of GaN(0 0 0 1) surface reconstructions

Epitaxiall Growth of Cubic and Hexagonal Gan Films on Gaas(001) Substrates by Mbe

Microstructural and Optical Properties of GaN Films on Nitrided Sapphire Substrates

Gallium Nitride Films Synthesized by Reactive Pulsed Laser Deposition from A Gaas Target

Liquid phase epitaxy of GaN films on sapphire substrates under an atmospheric pressure nitrogen ambience