Abstract:Direct coagulation casting is a novel near‐net‐shape method for forming ceramic green bodies from homogenous high‐solids‐loaded particle suspensions. It is based on the principle of the in situcoagulation of a powder suspension via a reaction‐rate‐controlled internal‐enzyme(urease)‐catalyzed reaction after casting. Low‐viscosity (<3 Pas) suspensions with a high solids loading (>62 vol%) of SiC, boron, and carbon powder mixtures with a high surface area (>7‐10 m2/g) have been prepared at pH = 10. Salt ions (up to 1‐2 mol/L) are created by the urease‐catalyzed decomposition of urea, to destabilize the suspensions. The coagulation kinetics and the strength of the wet green bodies have been investigated. The reaction rate is strongly dependent on the temperature (in the range of 5°‐30°C) and the enzyme concentration (for the range of 4‐16 units/g SiC) and is independent of the substrate (urea) concentration for urea concentrations of <2 wt%, based on the powder content. The resulting green bodies show no shrinkage during coagulation and 1%‐2% linear shrinkage during drying. The compressive strengths of the wet green bodies are as high as 60 kPa and increase as the coagulation time increases. The wet green strength of the coagulated suspensions scales with the solids content, according to a power law with an exponent of 11, in the range of 56‐61 vol% solids content. The possibilities of fabricating high‐solids‐containing complex SiC green and sintered components with homogenous microstructures and high sintered densities are demonstrated.

Study on gelcasting and properties of recrystallized silicon carbide

Study On Gelcasting Of Silicon Carbide

Study on Gelcasting of Silicon Nitride-Bonded Silicon Carbide Refractories

Preparation of High Concentrated Suspension and Gelcasting Process for Silicon Nitride Bonded Silicon Carbide Refractories

Colloid and Rheological Property of the Concentrated SiC/Si Suspensions

Gelcasting of Concentrated Aqueous Silicon Carbide Suspension

Formation of Silicon Nitride Bonded Silicon Carbide by Aqueous Gelcasting

Fabrication of ZrB 2 -Sic Ceramic Composites by Optimized Gel-Casting Method

Gas-discharging Reactions in Gelcasting of Si-containing Materials and Their Effect on Microstructure of Green Bodies

Gelcasting of silicon carbide based on gelation of sodium alginate

Direct Coagulation Casting of Silicon Carbide Suspension Via Polyelectrolyte Dispersant Crosslink Reaction

Gas-discharging reactions and their effect on the microstructures of green bodies in gelcasting of non-oxide materials

Study on the Process of Si3N4 Ceramic with High Properties by Gel-casting

Composite modification of fine SiC powder by 3-aminopropyl triethoxysilane and sodium polystyrene sulfonate and its slip casting study

Direct Coagulation Casting of Silicon Carbide Components

PREPARING Si3N4 CERAMICS WITH HIGH PERFORMANCES BY GELCASTING (I)INFLUENCE OF COATING Si3N4 POWDER ON MECHANICAL PROPERTIES OF THE MATERIAL

Water-Based Gelcasting of Surface-Coated Silicon Nitride Powder

Preparation of HEMA gel-casted SiC ceramics combined with LPS sintering

Sintering and behavior of nanometer tetragonal polycrystalline zirconia films by aqueous gel tape casting process

Aqueous Processing, Hot-Pressing and Mechanical Properties of Silicon Carbide with Al2O3 and Y2O3

Gel-Casting Of Fused Silica Ceramic And Its Sintering Process