Abstract:Gelcasting is a new ceramic forming technology for making complex-shaped ceramic products with high performance. The processes used in gelcasting are similar to processes often used in conventional ceramic forming process. However, when new high performance materials are introduced with the aim to improve the strength, defects such as air bubbles or agglomerates that can be found in many traditional ceramic materials are no longer be allowed since this would reduce the performance and reliability of the final ceramic products. The aim of this thesis project was to find an appropriate recipe of the ceramic suspension meanwhile improving the process of gelcasting and obtaining ceramic products with excellent mechanical behavior. To achieve this specified target, alumina and zirconia powders were studied in the following experiments which included rheological measurement of viscosity and storage modulus measurement for ceramic suspensions and drying shrinkage measurement of cast materials. The binder was burned out and the density was measured for ceramic materials sintered at different temperatures. The mechanical strength of sintered materials with high density was evaluated and the microstructure of fracture surfaces of ceramic samples was studied. Through rheological measurement, a good balance between fluidity and solid content of ceramic suspension was found. For alumina suspensions a solid content of 55vol% was selected and for zirconia solid contents of 46, 48 and 50vol% were studied. A monomer was dissolved in the suspension and an initiator was added to facilitate the polymerization of the monomer when the temperature was increased to around 70oC. The failure analysis of the fractured bending bars showed that the defects that caused the failure were not air bubbles but agglomerates. As a result, in future research for ceramic gelcasting with the intention to improve the mechanical strength, the suggestion is to use an appropriate recipe for the ceramic suspension and focus on elimination of granules and agglomerates from the suspension

Study on the Process of Si3N4 Ceramic with High Properties by Gel-casting

Gelcasting Preparation of Porous Silicon Nitride Ceramics by Adjusting the Content of Monomers

Preparation and Properties of Micro porous Si3N4 Ceramics by Gelcasting

Investigation of Gel Casting Preparation of Micro-Porous Si_3N_4 Ceramics

Study on Gelcasting of Si3N4-SiO2-BN Ceramic Composites and Performance

Study on Gelcasting of Silicon Nitride-Bonded Silicon Carbide Refractories

Preparation of High Concentrated Suspension and Gelcasting Process for Silicon Nitride Bonded Silicon Carbide Refractories

Microstructure and Properties of Porous Si3N4 Ceramics Fabricated by Gelcasting

Mechanical and dielectric properties of porous Si3N4 ceramics prepared by modified water‐based gel casting

Gel-casting Without De-Airing Process Using Silica Sol As a Binder

Gel Casting of High Strength Ceramics

PREPARING Si3N4 CERAMICS WITH HIGH PERFORMANCES BY GELCASTING (I)INFLUENCE OF COATING Si3N4 POWDER ON MECHANICAL PROPERTIES OF THE MATERIAL

Effect of solid contents on the mechanical properties of SiC-10 wt.%AlN ceramic composites prepared by gelcasting

Porous Si3N4 Ceramics Prepared by TBA-based Gel-casting

Microstructure and Properties of Si3N4 Based on Gelcasting

Preparation of porous Si 3 N 4 ceramics via tailoring solid loading of Si 3 N 4 slurry and Si 3 N 4 poly-hollow microsphere content

Gelcasting Process of Silicon Nitride Ceramics

Processing, Microstructures and Mechanical Properties of Aqueous Gelcasted and Solid-State-Sintered Porous Sic Ceramics

Preparation of Dense Mullite Ceramics through Gelcasting of Alumina Slurry Dispersed in Silica Sol

Mechanical and dielectric properties of gelcasted Si 3N 4 porous ceramic using CaHPO 4 as an additive

Gel-Casting Of Fused Silica Ceramic And Its Sintering Process