Abstract:It is difficult to form Si3N4 ceramics by DLP technology owing to the high refractive index and high ultraviolet (UV) absorption of Si3N4 powder. In this paper, the Si3N4 ceramics were successfully fabricated by DLP technology using Si3N4 powder coated with Al2O3-Y2O3 sintering additives. The effects of the coating amount of sintering additives on the properties of Si3N4 ceramic slurry, green bodies and parts after sintering were systematically studied. When Al(NO3)3 and Y(NO3)3 solutions were added at a content of 20 mL/100 g Si3N4, the slurry with lowest viscosity (0.042 Pa·s at a shear rate of 30 s−1) and a higher monolayer curing depth (47.9 ± 1.2 µm) was obtained, the relative density and flexural strength of the Si3N4 ceramics reached maximum values at 85.4% ± 0.3% and 149.2 ± 1.9 MPa. The shrinkage of the Si3N4 ceramics remained almost unchanged after coating Al2O3-Y2O3 sintering additives. Finally, the Si3N4 ceramics with excellent quality and clear outline were well prepared. This research has laid a certain experimental basis for DLP forming Si3N4 and other non-oxide ceramics, which is of great researching significance.

PREPARING Si3N4 CERAMICS WITH HIGH PERFORMANCES BY GELCASTING (I)INFLUENCE OF COATING Si3N4 POWDER ON MECHANICAL PROPERTIES OF THE MATERIAL

PREPARING Si3N4 CERAMICS WITH HIGH PERFORMANCE BY GELCASTING (II)-INFLUENCE OF CIP, POWDER OXIDIZATION AND GPS SCHEME ON PROPERTIES OF THE MATERIALS

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

Effect of Ceramic Powder on the Performance of Coating

Water-Based Gelcasting of Surface-Coated Silicon Nitride Powder

Preparation of Si3n4 Ceramics with High Strength and High Reliability Via A Processing Strategy

Microstructure and Properties of Si3N4 Based on Gelcasting

Preparation of High Concentrated Suspension and Gelcasting Process for Silicon Nitride Bonded Silicon Carbide Refractories

Study on the Process of Si3N4 Ceramic with High Properties by Gel-casting

The Gel-Casting Of Non-Oxide Ceramics

Preparation and Properties of Micro porous Si3N4 Ceramics by Gelcasting

Study on Gelcasting of Silicon Nitride-Bonded Silicon Carbide Refractories

PREPARATION OF NANO-SiO2-COATED Al2O3 CONCENTRATED SUSPENSION AND ITS GEL CASTING

Dispersion Properties of Silicon Nitride Powder Coated with Yttrium and Aluminium Precursors

Formation of Silicon Nitride Bonded Silicon Carbide by Aqueous Gelcasting

Influence of α-Si3N4 coarse powder on densification, microstructure, mechanical properties, and thermal behavior of silicon nitride ceramics

The Effect of Nano-Si<sub Align=right>3n<sub Align=right>4 on Properties of Silicon Nitride Ceramics

Colloid and Rheological Property of the Concentrated SiC/Si Suspensions

Study On Gelcasting Of Silicon Carbide

Preparation And Properties Of High Strength Porous Si3n4 Ceramics

Preparation and properties of Si3N4 ceramics via digital light processing using Si3N4 powder coated with Al2O3-Y2O3 sintering additives