Abstract:Direct coagulation casting is a novel near‐net‐shape method for forming ceramic green bodies from homogenous high‐solids‐loaded particle suspensions. It is based on the principle of the in situcoagulation of a powder suspension via a reaction‐rate‐controlled internal‐enzyme(urease)‐catalyzed reaction after casting. Low‐viscosity (<3 Pas) suspensions with a high solids loading (>62 vol%) of SiC, boron, and carbon powder mixtures with a high surface area (>7‐10 m2/g) have been prepared at pH = 10. Salt ions (up to 1‐2 mol/L) are created by the urease‐catalyzed decomposition of urea, to destabilize the suspensions. The coagulation kinetics and the strength of the wet green bodies have been investigated. The reaction rate is strongly dependent on the temperature (in the range of 5°‐30°C) and the enzyme concentration (for the range of 4‐16 units/g SiC) and is independent of the substrate (urea) concentration for urea concentrations of <2 wt%, based on the powder content. The resulting green bodies show no shrinkage during coagulation and 1%‐2% linear shrinkage during drying. The compressive strengths of the wet green bodies are as high as 60 kPa and increase as the coagulation time increases. The wet green strength of the coagulated suspensions scales with the solids content, according to a power law with an exponent of 11, in the range of 56‐61 vol% solids content. The possibilities of fabricating high‐solids‐containing complex SiC green and sintered components with homogenous microstructures and high sintered densities are demonstrated.

Direct Coagulation Casting of Silicon Carbide Components

Direct Coagulation Casting of Silicon Carbide Ceramics via Dispersant Reaction

Direct Coagulation Casting of Silicon Carbide Suspension Via Polyelectrolyte Dispersant Crosslink Reaction

Gelcasting of Concentrated Aqueous Silicon Carbide Suspension

Preparation of High Concentrated Suspension and Gelcasting Process for Silicon Nitride Bonded Silicon Carbide Refractories

Gelcasting of silicon carbide based on gelation of sodium alginate

Formation of Silicon Nitride Bonded Silicon Carbide by Aqueous Gelcasting

Direct Coagulation Casting of Silicon Nitride Suspension Via a Dispersant Reaction Method

Study on Gelcasting of Silicon Nitride-Bonded Silicon Carbide Refractories

Gas-discharging Reactions in Gelcasting of Si-containing Materials and Their Effect on Microstructure of Green Bodies

Gas-discharging reactions and their effect on the microstructures of green bodies in gelcasting of non-oxide materials

Study On Gelcasting Of Silicon Carbide

Preparation of low residual silicon content Si-SiC ceramics by binder jetting additive manufacturing and liquid silicon infiltration

Water-Based Gelcasting of Surface-Coated Silicon Nitride Powder

Colloid and Rheological Property of the Concentrated SiC/Si Suspensions

Direct Coagulation Casting of Alumina Suspension from Calcium Citrate Assisted by Ph Shift

Geometrically Complex Silicon Carbide Structures Fabricated by Robocasting

Fabrication, Structure and Properties of Porous SiC Ceramics with High Porosity and High Strength

Direct coagulation casting of alumina slurry and its technics

Preparation of silicon carbide ceramics using chemical treated powder by DCC via dispersant reaction and liquid phase sintering

Ceramic in-situ forming based on gelation of sodium alginate