Abstract:The liquid-solid coupling model of a constrained-layer damping oil pan as well as the infinite model of the radiation acoustic field were established. The vibration accelerations of bolts, which were loaded in bolt holes for calculating the radiation acoustic field, were measured. The simulated value of sound pressure was acquired at the point which is vertically 10 cm from the bottom center of the oil pan, and the value is extremely consistent with the measured value in the range of 500 to 3000 Hz, proving preciseness of the acoustic calculation. Total value of A-weighted sound pressure level of radiation noise and the loudness value were respectively regarded as the objectives to optimize the oil pan. The results indicated that the noise with less sound pressure may make the noise sound louder, and only if the sound quality parameters are considered as optimization objectives, the NVH performance can be consequently improved effectively. Finally, the adaptive simulated annealing algorithm was adopted to optimize the thickness of the layers of the constrained-layer damping oil pan, with the loudness of radiation noise as the optimization objective. The result shows that the loudness value declined by 27. 3% , reduced 40. 0 sone and the mass can be reduced by 21. 2% , and the NVH performance is promoted obviously.

A Research on Prediction and Reduction of Radiated Noise from Oil Pan of Diesel Engine

Research on Prediction Method of Radiated Noise of Engine Oil Pan

A Research on the Design of Low-noise Oil-pan Based on FEM and BEM

Numerical Analysis Of Noise Radiation Of Compressor Shell Considering Lubrication Oil

Study on the Identification of Noise Sources and Reducing Noise for Diesel Engine

Prediction of Engine Block's Radiation Noise and Low-Noise Design

Numerical analysis of the influence of lubrication oil on noise radiation of compressor shell

Numerical Analysis of Noise Radiation from Refrigerator Compressor Shell

Study of Noise Source Identification and Noise Control of A Gasoline Engine

Application of Virtual Prediction Method to Low-Noise Diesel Engine Design

Identification and Evaluation of Diesel Engine Noise Source Based on Acoustic Intensity

Prediction method of radiated noise by engine block

Low Noise Design of Oil Pan Based on Topography Optimization

Low-Noise Design of Stamping Parts in Diesel Engines

Vibration and noise reduction for a 490 diesel engine body

Finite Element Method Simulation Analysis for Sound Field of Exhaust Muffler

Research on Loudness of Radiation Noise of a Constrained-Layer Damping Oil Pan

Investigation of Multi-Degree of Freedom Damped Dynamic Absorber Applied to Wheel Noise Control

Experimental Study on Diesel Engine Noise

Integrated Virtual-Design Methods for Forecasting Radiated Noise of Single Cylinder Diesel Block

Coupled optimization of internal combustion engine radiated noise and interior noise