Abstract:Wet chemical etching is essential not only for processing silicon (Si) wafers but also for forming diverse structures, significantly promoting the development of the semiconductor industry. However, tight control of etched topography at the nanoscale and even atom-scale in a controllable and reproducible fashion can be hardly achieved in either laboratory research or industrial production, seriously hindering further enhancement of high-performance Si-based electronic devices. Herein, the roles of mechanically driven defects in wet etching were systematically investigated toward promoting controllable wet etching of monocrystalline Si. The role of antietching of mechanically driven amorphous Si (a-Si) and the role of promoting etching of distorted Si (including dislocations and stacking faults) were revealed in anisotropic or isotropic etchants. It was also found that the nucleation of nanocrystals in the a-Si area with increasing contact pressure can lead to deactivation of the antietching mask, and the required contact pressure for deactivation in KOH and tetramethyl ammonium hydroxide solutions was much higher than that in HF/HNO3 mixtures. The selective etching mechanisms for every defect including a-Si, distorted Si, and nanocrystals were further addressed down to the atom-scale based on the proposed dissolution model. This study provides insights into deeply understanding the role of defects in wet etching and pushes forward the idea of controllable wet chemical etching in the Si-based semiconductor industry.

Improvements of Semiconductor Etching Precision by Laser Assisted Wet Etching

Diffractive Characteristics of Laser Assisted Chemical Etching GaAs

Traceless Mitigation of Laser Damage Precursors on a Fused Silica Surface by Combining Reactive Ion Beam Etching with Dynamic Chemical Etching

Investigation on Laser Etch-Machining Underwater Based on Thermal-Mechanical Effect

Stress-Etching Using Laser Electrochemical Micromachining with Masks

Effective Approaches to Improve Au Etching Process Performance in MEMS Devices

Analysis of Linewidth Uniformity and Line Edge/Width Roughness in a 5 Nm Logic SAQP Process

Toward Controllable Wet Etching of Monocrystalline Silicon: Roles of Mechanically Driven Defects

Dry-etching-assisted femtosecond laser machining

Laser Direct Writing for Micromachining of Freeform Surface on n-Type GaAs via Photoelectrochemical Etching

Surface topography by water jet-guided laser texturing on wettability of monocrystalline silicon

Investigation on femtosecond laser combined with dynamic wet etching machining of SiC/SiC

A strategy to fabricate nanostructures with sub-nanometer line edge roughness

One-step fabrication of fine surfaces via femtosecond laser on sliced SiC

Effect of wet chemical etching on femtosecond laser fabricated surface microstructure of polycrystalline ZnS

Review on laser-induced etching processing technology for transparent hard and brittle materials

Femtosecond laser modification of silicon carbide substrates and its influence on CMP process

Controllable Preparation of Fused Silica Micro Lens Array through Femtosecond Laser Penetration-Induced Modification Assisted Wet Etching

Optimization of Wet strip after Metal Hard Mask All-in-One Etch for metal void reduction and yield improvement

Research on the mitigation of redeposition defects on the fused silica surface during wet etching process

Effect of Initial Surface Morphology and Laser Parameters on the Laser Polishing of Stainless Steel Manufactured by Laser Powder Bed Fusion