Abstract:The surface modification by ultra-fast laser could regulate the mechanical properties of hard and brittle materials. Since silicon carbide (SiC) is too hard to be machined with acceptable removal rate and quality by mechanical abrasives, and femtosecond laser (fs-laser) assisted grinding could be a potential method to improve the machinability of SiC. Under fs-laser modulating, SiC surface could be modified to generate laser-induced periodic surface structures (LIPSS). Understanding the mechanical properties and material removal mechanism of the LIPPS surface is crucial to accomplish a high efficiency and quality machining process. This paper aims to investigate the effects of fs-laser modification on the mechanical properties, removal mechanism, removal efficiency, and microstructure changes of 4H-SiC surface during removal, together with those of the original 4H-SiC surface for comparison. The hardness and elastic recovery ability of the modified layer are determined by nanoindentation test, and the nano-scratch test is adopted to study the materials removal behavior. The removal efficiency and the quality of the modified surface is significantly improved. Phase transformation is observed in the scratching area, which reveals the existence of ductile mode removal. Moreover, the stress distribution and the change of scratching force on the surface of SiC before and after modification are studied by finite element method (FEM). The results show that the stress distribution and transmission when scratched on the modified surface is lower than that of the original surface, and the scratching force under the same scratch conditions is greatly reduced. With the understanding of materials removal behavior from the whole process of deformation, phase transformation, and separation of LIPPS from substrate, then the fs-laser modification of SiC could be evidenced as an effective method to improve the grinding efficiency and quality in mass production of industry.

One-step fabrication of fine surfaces via femtosecond laser on sliced SiC

Centimeter-scale low-damage micromachining on single-crystal 4H–SiC substrates using a femtosecond laser with square-shaped Flat-Top focus spots

Surface Micromorphology and Nanostructures Evolution in Hybrid Laser Processes of Slicing and Polishing Single Crystal 4H-Sic

Investigation on the underwater femtosecond laser polishing SiC ceramic

Femtosecond laser modification of silicon carbide substrates and its influence on CMP process

Influence of surface morphology and processing parameters on polishing of silicon carbide ceramics using femtosecond laser pulses

An experimental investigation of scan trajectory into the underwater femtosecond laser polishing SiC ceramic

Surface modulation to enhance chemical mechanical polishing performance of sliced silicon carbide Si-face

Materials removal mechanism of single crystalline SiC with laser-induced periodic surface structures (LIPSS)

Investigation on ultrasonic vibration-assisted femtosecond laser polishing of C/SiC composites

Study of Femtosecond Laser Ablation and Polishing Process on 4H-SiC Substrate

Improving Polishing Efficiency of RB-SiC through Femtosecond Laser Pretreatment

Femtosecond laser polishing of SiC/SiC composites: Effect of incident angle on surface topography and oxidation

Influence Of Pulse Energy And Scanning Speed Of Femtosecond Laser On Surface Roughness Of Sic Ceramics

Optimizing the flatness of 4H-silicon carbide wafers by tuning the sequence of lapping

Femtosecond Laser Modification of Silicon Carbide to Improve the Materials Removal Efficiency

Surface Topography and Subsurface Structure Evolution in Laser Micro Polishing of Monocrystalline Silicon

Effects of Incidence Angle and Optimization in Femtosecond Laser Polishing of C/SiC Composites

Influence of Pulse Energy and Defocus Amount on the Mechanism and Surface Characteristics of Femtosecond Laser Polishing of SiC Ceramics

Picosecond Laser-Assisted Chemical Mechanical Polishing (CMP): Aiming at the Si-Face of Single-Crystal 6H-Sic Wafer

High speed and low roughness micromachining of silicon carbide by plasma etching aided femtosecond laser processing