Abstract:A novel microelecromechnical system (MEMS) inertial switch based on the surface micromachining technology was developed, which mainly consists of a proof mass as the movable electrode and a compliant stationary electrode above the proof mass, whose deformation during the contact process would enhance the contact effect and prolong the switch-on time. Based on the original design which had already realized the enhancing effect to some extent, the device structure was redesigned as a centrosymmetric structure with the stationary electrode changed from two bridge-type beams to one cross beam in order to reduce the off-axis sensitivity. More importantly, a contact point was installed on top of the proof mass, changing the effective contact area of the stationary electrode from its end to the center, which undergoes the largest deformation. Therefore, the contact effect would be improved further, which has been confirmed by the ANSYS transient simulation. This simulation combined with the Simulink dynamic simulation described the device behavior, which were in agreement with the drop hammer tests. The threshold acceleration of the redesigned inertial microswitch was around 70 g, and the tested switch-on time reached 30 mus, more satisfactory than the original design.

Research on Electro-mechanical Performance of Switch for MEMS Distributed Phaser Working in X Band

Electromechanical Design of Low-Driven Voltage Capacitive Switches Based on Ka-Bank Distributed MEMS Phase Shifters

The mechanical behavior investigation of MEMS switches for millimeter wave phase shifters

Research on the RF-MEMS switch with low elasticity coefficient in the X-band phase shifter

Structural design of novel low-actuation MEMS switches for X-band application

An Impedance Analysis of MEMS Membrane Switches for X-Band Application

Analysis and design of MEMS capacitive switch for microwave distributed phase shifter

Investigation of Design and Vibration Modes of Low-Voltage Driven RF MEME Capacitive Switch for Millimeter Distributed Phase Shifter

Research of a X-Band MEMS Single-Pole-Double-Throw (SPDT) Switch

A Novel X-Bands RF MEMS Switch with Enhanced Power Handlings

Actuated Voltage Shift Mechanisms Of Mems Capacitive Switch Based On Distributed Phase Shifter

Micromechanical Structural Design of Electromagnetically Actuated Bistable RF Micro-Electro-Mechanical Systems Switches

Numerical Analysis of Pull-In Voltage for Contact Mems Switches in Switched-Line Phase Shifter Application

Progress on MEMS Switches for Microwave Circuits

Research and Design of SPDT RF MEMS Switch

Preparing of a High Speed Bistable Electromagnetic RF MEMS Switch

Development of a Novel MEMS Inertial Switch with a Compliant Stationary Electrode

A Novel Design and Fabrication of MEMS Electrical Inertia Micro-switch

DC-contact Series Radio-Frequency Micro Electromechanical System Switch with Slanting Beams

Capacitive Rf MEMS Switch with Composite Beam

Design of A Novel Bulk Micro-Machined Rf Mems Switch