Abstract:Development of alternative thin film photovoltaic technologies is an important research topic due to the potential for low-cost, large-scale fabrication of high-efficiency solar cells. Despite the large number of promising alternative absorbers and corresponding contacts, the rate of progress is limited by complications that arise during solar cell fabrication. One potential solution to this problem is the high-throughput combinatorial method, which has been extensively used for research and development of individual absorber and contact materials. Here, we demonstrate an accelerated approach to development of thin film photovoltaic device prototypes based on the novel CuSbS2 absorber, using the device architecture employed for CuInxGa(1-x)Se2 (CIGS). The newly developed three-stage, self-regulated CuSbS2 growth process enables the study of PV device performance trends as a function of phase purity, crystallographic orientation, layer thickness of the absorber, and numerous back contacts. This exploration results in initial CuSbS2 device prototypes with ~1% conversion efficiency; currently limited by low short-circuit current due to poor collection of photoexcited electrons, and a small open-circuit voltage due to a cliff-type conduction band offset at the CuSbS2/CdS interface (suggested by first-principles calculations). Overall, these results illustrate the potential of combinatorial methods to accelerate the development of thin film photovoltaic devices with novel absorbers.

Growth and photovoltaic device using Cu3VS4 films prepared via co-sputtering from Cu–V and V targets

Preparation and Characterization of Cuins2 Thin Films for Solar Cells by Chemical Bath Deposition

Synthesis and Characterization of Hydrazine Solution Processed Cu12Sb4S13 Film

Study of copper bismuth sulfide thin films for the photovoltaic application

Electronic structure, defect properties, and optimization of band gap of the earth-abundant and low-toxicity photovoltaic absorber Cu3SbS4

In-situ Growth of a CdS Window Layer by Vacuum Thermal Evaporation for CIGS Thin Film Solar Cell Applications

Metal Precursor with Bi-Layer Indium for Cu(In,Ga)Se2 Thin Film Preparation

Optimization of preparation conditions and design of device configurations for Cu3AsS4 solar cells: a combined study of first-principles calculations and SCAPS-1D device simulations

A promising photovoltaic material Cu2MnSn(S,Se)4: Film growth and its application in solar cell

Electronic Structure, Defect Properties, and Optimization of the Band Gap of the Earth-Abundant and Low-Toxicity Photovoltaic Absorber Cu3SbS4.

CuSbS2 As a Promising Earth-Abundant Photovoltaic Absorber Material: A Combined Theoretical and Experimental Study

Thin film solar cells based on Ag-substituted CuSbS2 absorber

All-Layer Sputtering-Free Cu2Zn1-xCdxSnS4 Solar Cell with Efficiency Exceeding 7.5%

Efficient planar antimony sulfide thin film photovoltaics with large grain and preferential growth

Accelerated development of CuSbS2 thin film photovoltaic device prototypes

Synthesis, Growth and Characterization of Cu2CoSnS4 Thin Films via Thermal Evaporation Method

Effects of the growth process on surface morphology of Cu2(Sn1−xGex)S3 thin films

Fabrication of phase-pure and large-grained Cu3BiS3 films by a two-stage process for thin film solar cells

Facile Growth of Cu2ZnSnS4 Thin-Film by One-Step Pulsed Hybrid Electrophoretic and Electroplating Deposition

Fabrication of Cu2SnS3 Thin Film Solar Cells Via a Sol-Gel Technique in Air

Modeling and optimization of numerical studies on CuSbS 2 thin film solar cell with ∼ 15% efficiency