Abstract:Recently, CuSbS2 has been proposed as an alternative earth-abundant absorber material for thin film solar cells. However, no systematic study on the chemical, optical, and electrical properties of CuSbS2 has been reported. Using density functional theory (DFT) calculations, we showed that CuSbS2 has superior defect physics with extremely low concentration of recombination-center defects within the forbidden gap, espeically under the S rich condition. It has intrinsically p-type conductivity, which is determined by the dominant Cu vacancy (V-Cu) defects with the a shallow ionization level and the lowest formation energy. Using a hydrazine based solution process, phase-pure, highly crystalline CuSbS2 film with large grain size was successfully obtained. Optical absorption investigation revealed that our CuSbS2 has a direct band gap of 1.4 eV. Ultraviolet photoelectron spectroscopy (UPS) study showed that the conduction band and valence band are located at 3.85 eV and -5.25 eV relative to the vacuum level, respectively. As the calculations predicted, a p-type conductivity is observed in the Hall effect measurements with a hole concentration of similar to 10(18) cm(-3) and hole mobility of 49 cm(2)/(V s). Finally, we have built a prototype FTO/CuSbS2/CdS/ZnO/ZnO:Al/Au solar cell and achieved 0.50% solar conversion efficiency. Our theoretical and experimental investigation confirmed that CuSbS2 is indeed a very promising absorber material for solar cell application.

Synthesis and Characterization of Hydrazine Solution Processed Cu12Sb4S13 Film

Synthesis and Characterization of Bi2S3 Quantum Dot-Sensitized TiO2 Nanorod Arrays Coated with ZnSe Passivation Layers

Hydrazine Solution Processed Cusbse2: Temperature Dependent Phase and Crystal Orientation Evolution

CuSbS2 As a Promising Earth-Abundant Photovoltaic Absorber Material: A Combined Theoretical and Experimental Study

Preparation and Characterization of Cuins2 Thin Films for Solar Cells by Chemical Bath Deposition

Non-Hydrazine Solution Processed Culn(Se,S)(2) Photovoltaic Device

Hydrazine solution processed Sb2S3, Sb2Se3 and Sb2(S(1-x)Se(x))3 film: molecular precursor identification, film fabrication and band gap tuning

Chemical synthesis of Cu(In) metal inks to prepare CuInS2 thin films and solar cells

CuSbSe2 As a Potential Photovoltaic Absorber Material: Studies from Theory to Experiment

Colloidal synthesis of zincblende Cu3InSnS5 nanocrystals and their application in the thin-film solar cell

Low-cost Fabrication of Cu 2 ZnSnS 4 Thin Films for Solar Cell Absorber Layers

Structure, Morphology, and Photoelectric Performances of Te-Sb 2 Se 3 Thin Film Prepared via Magnetron Sputtering.

A promising photovoltaic material Cu2MnSn(S,Se)4: Film growth and its application in solar cell

Non‐Hydrazine Solutions in Processing CuIn(S,Se)2 Photovoltaic Devices from Hydrazinium Precursors

Thin-Film Solar Cells Based on Selenized CuSbS2 Absorber

Electronic structure, defect properties, and optimization of band gap of the earth-abundant and low-toxicity photovoltaic absorber Cu3SbS4

Fabrication of phase-pure and large-grained Cu3BiS3 films by a two-stage process for thin film solar cells

Synthesis and characterization of CZTS and Cu2-xAgxZnSnS4 thin films for the application of solar cells

Electronic Structure, Defect Properties, and Optimization of the Band Gap of the Earth-Abundant and Low-Toxicity Photovoltaic Absorber Cu3SbS4.

Thin film solar cells based on Ag-substituted CuSbS2 absorber