Abstract:Ash aerosol and ash deposit formation during oxy-coal combustion were explored through experiments in a self-sustained 100kW rated down-fired oxy-fuel combustor. Inlet oxidant conditions consisted of 50% inlet oxygen with CO2 (hereafter denoted as OXY50 conditions). A Berner low pressure impactor (BLPI), a scanning mobility particle sizer (SMPS), and an aerodynamic particle sizer (APS) were used to obtain size segregated ash aerosol samples and to determine the particle size distributions (PSD). A novel surface temperature controlled ash deposition probe system that allowed inside and outside deposits to be separated was used to collect the ash deposits. The ash aerosol PSDs given by the BLPI and those produced by SMPS/APS were consistent with each other. Data suggested that oxy-coal combustion under these conditions did not change the formation mechanisms controlling the bulk ash aerosol composition, but it did increase the formation of ultra-fine particles initially formed through metal vaporization, due to increased vaporization of silicon at the higher combustion temperature. The smaller particles contained within the deposits had higher Si and lower Na and S concentrations under OXY50 conditions than for air combustion. Moreover, the ash aerosol composition for particle sizes less than 2.4μm was related to the composition of the inside deposits. A higher Na in the ash aerosol resulted in higher Na in inside deposits with comparable absolute Na concentrations in both those aerosol particles and those inside deposits particles. The contribution of S and Si to the inside deposits showed that S in the vaporization modes together with Si in the ultrafine vaporization mode, contributed significantly to the composition of the inside deposits. These results provided direct evidence that prediction of the chemistry of the initial deposit layer (but not of the bulk deposits) required knowledge of the size segregated chemistry of the ash aerosol.

Investigation on formation mechanisms of ash and deposit from cotton stalk vibrating grate boiler combustion based on their characteristics

Analysis of Formation and Growth Process of Ash Deposition on the Convective Heating Surface of a 400t/d MSW Incinerator Based on Different Operating Days

Investigation of Ash Deposition Dynamic Process in an Industrial Biomass CFB Boiler Burning High-Alkali and Low-Chlorine Fuel

Investigation of Ash Deposition Characteristics in Full-Scale Circulating Fluidized Bed Boiler Burning Zhundong Coal

Mechanism of biomass ash slagging

Effect of Chemical Compositions on Ash Fusibility Characterization of a Jincheng Anthracite During Combustion and Gasification

Ash formation characteristics in co-combusting coagulation sludge and Zhundong coal

Analysis on Deposition Mechanism of Ash with High Ash Fusion Temperatures on the Heat-insulation Layer in Boiler

An Experimental Investigation into the Characteristics and Deposition Mechanism of High-Viscosity Coal Ash

Experimental Investigation On Three Coals Ash Formation

Formation of Ash Deposit Within Residual Oil Burning Boilers

Effects of sludge on the ash fusion behaviors of corn stalk and its modification mechanisms

EXPERIMENTAL STUDY OF ASH DEPOSIT DURING CO-FIRING SAWDUST AND COAL

A Study Of The Composition Of Ash Deposits In An Fbc System

Investigation of ash deposition dynamic process in an industrial biomass CFB boiler burning high alkali and chlorine fuel

Ash Aerosol Formation from Oxy-Coal Combustion and Its Relation to Ash Deposit Chemistry

The morphological and mineralogical characteristics and thermal conductivity of ash deposits in a 220 MW CFBB firing Zhundong lignite

Carbon Formation Mechanism in Fly Ash of Circulating Fluidized Bed Boilers

Influence of Ash Characteristics on Ash Deposition in Coal Fired Boiler

Research on the Dynamic Characteristic of Ash Deposition in Boilers Burning Coal and Coal Water Slurry

Ash Deposition of Zhundong Coal in a 350 MW Pulverized Coal Furnace: Influence of Sulfation