Abstract:The ultra-low dielectric constant (ULK) materials is implemented in the copper/low-k interconnection structures in industry in order to minimize the RC delay and crosstalk noise. The mechanical property of ULK dielectrics is weak compared to traditional dielectrics. So it poses a significant risk to the device reliability, not only in the fabrication process, but also in packaging processes and reliability tests. When using numerical simulations to assess the structural integrity associated with low-k integration, accurate mechanical property of ULK materials is also an important parameter that needed to be measured. In this paper, we present a method of measuring the mechanical properties of ULK materials. This method is suitable for a variety of materials which can be deposited or grown on a silicon substrate. The fabricating processes mainly include lithography, temporary bonding, grinding, Si etching and debonding. In addition, we designed two kinds of test structures. One is with pre-crack, and the other is without pre-crack. Each structure has two kinds of geometry sizes. The tensile test was done by using the in-situ tensiometer apparatus with uniaxial stretching. The stress-strain diagrams of the specimens show an elastic modulus $\mathbf{E=1.2}$ GPa and tensile strength is about 13.5 Mpa for the structure without pre-crack, which is lower than that of bulk low-k material. The samples with two kinds of geometry sizes have similar modulus values which can be converted by the measured results from the diagram. While other specimens show a critical energy release rate ${\mathrm{G}_{\mathrm{c}}=0.25\mathrm{J}/\mathrm{m}^{2}}$ for the structure with pre-crack, which is also lower than that of bulk material. The results illustrate that the ability to resist fracture of low-k thin films is weak. It provides a possible method to measure the mechanical properties of ULK thin films.

Noncontact dielectric constant metrology of low-k interconnect films using a near-field scanned microwave probe

Local Permittivity Measurement of Dielectric Materials Based on the Non-Contact Force Curve of Microwave Atomic Force Microscopy

Measurement of Dielectric Constant of Thin Film Materials at Microwave Frequencies

Noncontact Measurement of Complex Permittivity of Electrically Small Samples at Microwave Frequencies

Measurement of Complex Permittivity in Microwave Frequency of Thin Film Materials

Contactless Measurement of Thin Film Conductivity by A Microwave Compact Equipment

Nondestructive Measurement and High-Precision Evaluation of the Electrical Conductivity of Doped GaAs Wafers Using Microwaves.

Nondestructive method of thin film dielectric constant measurements by two-wire capacitor

A Methodology for Quantitative Evaluation of Local Electrical Conductivity: from Micron to Submicron

Calibration of shielded microwave probes using bulk dielectrics

Study on the mechanical properties of ultra-low dielectric film by tensile test

Parameter-free extraction of Thin-Film Dielectric Constants from Scanning Near Field Microwave Microscope Measurements

Quantitative imaging of dielectric permittivity and tunability with a near-field scanning microwave microscope

Evaluation of a New Advanced Low-k Material

Attenuation Measurement of the Dielectric Rod Using Parallel Strips with a Resonable Field Environment

Traceable Nanoscale Measurements of High Dielectric Constant by Scanning Microwave Microscopy

Roll-to-Roll In-Line Implementation of Microwave Free-Space Non-Destructive Evaluation of Conductive Composite Thin Layer Materials

3D Imaging and Quantitative Subsurface Dielectric Constant Measurement Using Peak Force Kelvin Probe Force Microscopy (Adv. Mater. Interfaces 2/2024)

Direct measurement of in-plane thermal conductivity of microscale suspended thin films using a novel 3ω method

Nondestructive Imaging of the Microwave Properties of Superconducting Thin Film Devices with a Scanning Microwave Near-Field Microscope

A Method to Determine Broadband Complex Permittivity of Thin Film Dielectric Materials up to 60 GHz