Abstract:Non-destructive tests working at lower microwave frequencies have large advantages of dielectric material penetrability, lower equipment cost, and lower implementation complexity. However, the resolution will become worse as the work frequencies become lower. Relying on designing the structure of high field confinement, this study realizes a simple complementary spiral resonators (CSRs)-based near-field probe for microwave non-destructive testing (NDT) and imaging around 390 MHz (λ = 769 mm) whereby very high resolution (λ/308, 2.5 mm) is achieved. By applying an ingenious structure where a short microstrip is connected to a microstrip ring to feed the CSR, the probe, that is a single-port microwave planar circuit, does not need any extra matching circuits, which has more application potential in sensor arraying compared with other microwave probes. The variation of the electric field distribution with the standoff distance (SOD) between the material under test and the probe are analyzed to reveal the operation mechanisms behind the improved sensitivity and resolution of the proposed probe. Besides, the detection abilities of the tiny defects in metal and non-metal materials are demonstrated by the related experiments. The smallest detectable crack and via in the non-metal materials and the metal materials are of a λ/1538 (0.5 mm) width, a λ/513 (1.5 mm) diameter, a λ/3846 (0.2 mm) width and a λ/513 (1.5 mm) diameter, respectively. Moreover, to further evaluate the performance of the proposed probe, the defects under skin layer in the multilayer composite materials and the defects under corrosion in the carbon steel are inspected and imaged. Due to lower work frequency, high resolution, outstanding detection abilities of tiny defects, and large potentials in sensor arraying, the proposed probe would be a good candidate for microwave NDT and imaging.

Calibration of shielded microwave probes using bulk dielectrics

Batch-fabricated Cantilever Probes with Electrical Shielding for Nanoscale Dielectric and Conductivity Imaging

MMIC on-Wafer Test Method Based on Hybrid Balanced and Unbalanced RF Pad Structures

Modeling of a Cantilever-Based Near-Field Scanning Microwave Microscope

A Shielded Cantilever-Tip Microwave Probe For Micro/Nano Surface Imaging Of Conductive Properties

An Efficient Probe Calibration Based Near-Field to Near-Field Transformation for EMI Diagnosis

Study on a Miniaturized Microwave Near-Field Probe Based on Split Ring Resonator

A Miniature Multi-Component Probe for Near-Field Scanning

Design of Microstrip Line used for Probe Calibration up to 40 GHz

A Simple High-resolution Near-field Probe for Microwave Non-Destructive Test and Imaging

A Wideband EzEx Field Probe Integrated with a Strip Line Magic-T

Fabrication of oscillating metal probe for dynamic scanning microwave microscopy

Structure Modification of M-AFM Probe for the Measurement of Local Conductivity

J0610104 Evaluation of Interatomic Force on the Tip of Probe by Using Microwave Atomic Force Microscope

Noncontact dielectric constant metrology of low-k interconnect films using a near-field scanned microwave probe

High-resolution Probe Design for Measuring the Dielectric Properties of Human Tissues

T0401-2-1 Development of a Microwave AFM Probe for the Evaluation of Electrical Properties

Noncontact Measurement of Complex Permittivity of Electrically Small Samples at Microwave Frequencies

Probe Design and Source Reconstruction for Near-Field Scanning and Modeling

Shielded cantilever with on-chip interferometer circuit for THz scanning probe impedance microscopy

Shielded Piezoresistive Cantilever Probes for Nanoscale Topography and Electrical Imaging