Abstract:Accurate measurements of the nanoscale electromechanical coupling in materials, including piezo and ferroelectrics, twisted 2D layers, and biological systems is of both fundamental scientific and applied importance. Piezoresponse Force Microscopy (PFM) is capable of detecting strains in these materials, down to the picometer range. Following the emergence of weaker materials, the smaller signals associated with them have revealed various crosstalk challenges that have limited the accuracy of measurements. Previous work demonstrated that the use of an interferometric displacement sensor (IDS) positioned appropriately above the tip of the cantilever (x/L~1), where x is the spot position and L is the cantilever length, has enabled sensitive and artifact-free electromechanical measurements. A similar approach has been employed in removing unwanted electrostatic and in-plane response contributions for the optical beam deflection (OBD) measurement technique commonly used in most atomic force microscopes. In the present study, extensive automated sub-resonance spot position dependent PFM measurements were conducted on periodically poled lithium niobate (PPLN). In this work, both IDS and OBD responses were measured simultaneously, allowing direct comparisons of the two approaches. The IDS showed a blind spot at x/L~1, as expected. However, for OBD measurements, the blind spot's location exhibited wider variation, ranging from 0.15<x/L<0.61. Furthermore, the magnitudes of the amplitudes measured with IDS and OBD were typically different, sometimes approaching disagreement by a factor of two. These measurements have important implications, not only for the PPLN measured here, but for more complex and unknown samples that have a heterogeneous polarization and electrical characteristic.

3D Imaging and Quantitative Subsurface Dielectric Constant Measurement Using Peak Force Kelvin Probe Force Microscopy (Adv. Mater. Interfaces 2/2024)

Electrokinetics In Micro-Channeled Cantilevers: Extending The Toolbox For Reversible Colloidal Probes And Afm-Based Nanofluidics

Accurate 3D Nanoscale Electromechanical Imaging with a Metrological Atomic Force Microscope

Interface Probing by Dielectric Frequency Dispersion in Carbon Nanocomposites

Spatially Resolved High Voltage Kelvin Probe Force Microcopy: A Novel Avenue for Examining Electrical Phenomena at Nanoscale

Pulsed Force Kelvin Probe Force Microscopy through Integration of Lock-In Detection

Traceable Nanoscale Measurements of High Dielectric Constant by Scanning Microwave Microscopy

Measurement of Sub-Surface Microstructures Based on a Developed Ultrasonic Atomic Force Microscopy

Quantitative Electromechanical Atomic Force Microscopy

Local Permittivity Measurement of Dielectric Materials Based on the Non-Contact Force Curve of Microwave Atomic Force Microscopy

Kelvin Probe Force Microscopy and Its Application

Spatial mapping of photovoltage and light-induced displacement of on-chip coupled piezo/photodiodes by Kelvin probe force microscopy under modulated illumination

Quantification of surface displacements and electromechanical phenomena via dynamic atomic force microscopy

Accurate Vertical Nanoelectromechanical Measurements

Integrated Tapping Mode Kelvin Probe Force Microscopy with Photoinduced Force Microscopy for Correlative Chemical and Surface Potential Mapping

Contactless Characterization of Electronic Properties of Nanomaterials Using Dielectric Force Microscopy

Full data acquisition in Kelvin Probe Force Microscopy: Mapping dynamic electric phenomena in real space

Single-Harmonic Response Open-Loop Kelvin-Probe Force Microscopy

Sub-10 nm Probing of Ferroelectricity in Heterogeneous Materials by Machine Learning Enabled Contact Kelvin Probe Force Microscopy

Quantitative imaging of dielectric permittivity and tunability with a near-field scanning microwave microscope

Surface Potential Modeling and Reconstruction in Kelvin Probe Force Microscopy