Abstract:One of the most important limitations of the atomic force microscopy (AFM) is scanning speed, whose high values are required for contemporary high-resolution, long-range diagnostic applications. The measurement bandwidth of an AFM depends on several factors, but usually results from the time constant of the oscillating cantilever, which is correlated with its resonance frequency and quality factor. We propose a method to overcome this problem by performing the surface measurements when the cantilever is vibrating in higher eigenmodes. In this paper we demonstrate the application of active piezoresistive cantilevers operating in this mode. The active piezoresistive cantilever comprises a piezoresistive deflection sensor, a deflection actuator and a nanotip. It is a complete micro-electro-mechanical system (MEMS), ensuring the highest reliability of cantilever vibration control and detection. Higher eigenmode operations are usually difficult to implement as they usually result in lower deflection and lower sensitivity of the probe vibration deflection. Here we present an experimental modification of the structure of an active piezoresistive cantilever using focused ion beam (FIB) machining that mitigates both weaknesses. This has enabled the cantilever to scan the surface at a scanning rate of 10 lines/s with a maximum speed of 500 μm/s and a data acquisition rate of 10 kS/s, when the probe is vibrating at 380 kHz in the second eigenmode. We also describe a traceable calibration routine (based on analysis of the response of the piezoresistive detector, the output of the HeNe interferometer and precise control of the deflection actuator), together with the cantilever modification process and the development of the measurement setup. We show measurement results of dedicated calibration samples and silicon carbide crystal lattice references.

Quantification of surface displacements and electromechanical phenomena via dynamic atomic force microscopy

Towards High Accuracy Surface Profile Characterization in Atomic Force Microscopy

Improved Sensitivity for Subsurface Imaging by Contact Resonance Atomic Force Microscopy Using Fano Peaks

Quantitative Electromechanical Atomic Force Microscopy

Accurate 3D Nanoscale Electromechanical Imaging with a Metrological Atomic Force Microscope

Quantitative Measurements of Shear Displacement Using Atomic Force Microscopy

Quantitative Measurements of Electromechanical Response with a Metrological Atomic Force Microscope

Accurate Vertical Nanoelectromechanical Measurements

Decoupling competing electromechanical mechanisms in dynamic atomic force microscopy

Wide-Range Scanner With Hinge Mechanism And Its Application In Atomic Force Microscope

Application of active piezoresistive cantilevers in high-eigenmode surface imaging

Measurement of Sub-Surface Microstructures Based on a Developed Ultrasonic Atomic Force Microscopy

Interaction imaging with amplitude-dependence force spectroscopy

Double-peak resonant mapping of cellular viscoelasticity in force-clamp detection of atomic force microscope

Investigation of Near-Surface Mechanical Properties of Materials Using Atomic Force Microscopy

Very high frequency probes for atomic force microscopy with silicon optomechanics

Hyperelastic Microcantilever AFM: Efficient Detection Mechanism Based on Principal Parametric Resonance

Nanoscale In-Plane Displacement Evaluation by AFM Scanning and Digital Image Correlation Processing

A Novel Topography and Elasticity Synchronous Measure Approach With an AFM

Quantitative dynamic force microscopy with inclined tip oscillation

Dynamical Characterization of Micro Cantilevers by Different Excitation Methods in Dynamic Atomic Force Microscopy.