Accurate 3D Nanoscale Electromechanical Imaging with a Metrological Atomic Force Microscope

Roger Proksch,Ryan Wagner

2024-10-04

Abstract:We demonstrate an interferometric piezoresponse force microscopy (PFM) method for quantifying the full, three-dimensional response of piezoelectric material without requiring sample rotation. We show that this approach yields quantitative 3D measurement independent of the sample orientation beneath the tip. This approach simplifies existing, angle-resolved PFM techniques, since it only requires four measurements (or three with less redundancy and error checking) to map the full three dimensional, time independent strain field. It also does not require rotating the sample with respect to the cantilever. It benefits from the greatly reduced noise floor of our laser doppler vibrometer interferometric displacement sensor (IDS) of 50fm per rootHz or our quadrature phase differential interferometer (QPDI) noise floor of 5fm per rootHz and the intrinsic accuracy of interferometric measurements. One important result is that the in-plane piezo sensitivities were systematically smaller than the vertical by a factor of 2 to 3. A simple analysis of vertical and lateral contact stiffnesses, due to the difference in the Young (vertical) and Shear (lateral) sample moduli predicts a factor of 2.5, in good agreement with the measurements. Finally, we fit observed OBD measurements to a linear combination of interferometrically measured in-plane and vertical responses for four different ferroelectric samples. We found that the in-plane response accounted for 20% or more of the OBD response and surprisingly, in two out of the four samples, the in-plane contribution was in fact 2x larger than the vertical.

Mesoscale and Nanoscale Physics