Abstract:We demonstrate an interferometric piezoresponse force microscopy (PFM) method for quantifying the full, three-dimensional response of piezoelectric material without requiring sample rotation. We show that this approach yields quantitative 3D measurement independent of the sample orientation beneath the tip. This approach simplifies existing, angle-resolved PFM techniques, since it only requires four measurements (or three with less redundancy and error checking) to map the full three dimensional, time independent strain field. It also does not require rotating the sample with respect to the cantilever. It benefits from the greatly reduced noise floor of our laser doppler vibrometer interferometric displacement sensor (IDS) of 50fm per rootHz or our quadrature phase differential interferometer (QPDI) noise floor of 5fm per rootHz and the intrinsic accuracy of interferometric measurements. One important result is that the in-plane piezo sensitivities were systematically smaller than the vertical by a factor of 2 to 3. A simple analysis of vertical and lateral contact stiffnesses, due to the difference in the Young (vertical) and Shear (lateral) sample moduli predicts a factor of 2.5, in good agreement with the measurements. Finally, we fit observed OBD measurements to a linear combination of interferometrically measured in-plane and vertical responses for four different ferroelectric samples. We found that the in-plane response accounted for 20% or more of the OBD response and surprisingly, in two out of the four samples, the in-plane contribution was in fact 2x larger than the vertical.

Nanoscale Ferroelectric Characterization with Heterodyne Megasonic Piezoresponse Force Microscopy

A New Heterodyne Megasonic Piezoresponse Force Microscopy with High-frequency Excitation beyond 100 MHz

Force-Electric Coupling of Nanoscale Ferroelectric Domains Based on Piezoelectric Force Microscopy (PFM)

Variation of contact resonance frequency during domain switching in PFM measurements for ferroelectric materials

PFM (piezoresponse force microscopy)-aided design for molecular ferroelectrics

Nanoelectromechanics of Piezoresponse Force Microscopy

Breaking the Fundamental Limitations of Nanoscale Ferroelectric Characterization: Non‐Contact Heterodyne Electrostrain Force Microscopy (Small Methods 11/2021)

Differentiating Ferroelectric and Nonferroelectric Electromechanical Effects with Scanning Probe Microscopy.

Probing Electromechanical Behaviors by Datacube Piezoresponse Force Microscopy in Ambient and Aqueous Environments

Exploring Nanoscale Ferroelectricity in Doped Hafnium Oxide by Interferometric Piezoresponse Force Microscopy

Nanoscale Insight Of High Piezoelectricity In High-T-C Pmn-Ph-Pt Ceramics

Quantitative Lateral and Vertical Piezoresponse Force Microscopy on A Pbtio3 Single Crystal

Scanning Probe Microscopy of Ferroelectric Domains in PMN-PT Single Crystal

Accurate 3D Nanoscale Electromechanical Imaging with a Metrological Atomic Force Microscope

High-Temperature Piezoresponse Force Microscopy

Piezoresponse Force Spectroscopy of Ferroelectric Materials

Non-piezoelectric effects in piezoresponse force microscopy

Nanoscale Piezoresponse, Acoustic and Thermal Microscopy of Electronic Ceramics

Investigation on Microscopic Mechanisms of High-Curie Temperature PMN-PH-PT Piezoelectric Ceramics

Decoding Apparent Ferroelectricity in Perovskite Nanofibers.