Abstract:<p>Error has been long recognized as ubiquitous to the practice of electrical engineering for failure analysis, however, the correct methodology for decision science is necessary, especially with more statistical data analysis, in this research a new methodology proposal for update the international standard IEC 60076, by using the root cause analysis, with traditional methods, principal components analysis, data mining and causal map, it is possible to eliminate the error, in this analysis an update for the standards have been discovered, they need to improve to avoid critical failures in the power system, for the shunt reactors. This research explores the failure mode and root cause analysis of shunt reactors in high voltage through examination of the design and implementation in Latin American. The case study has been evaluated for a shunt reactor in the 500 kV power system, and a discussion is considered for 279 shunt reactors, they were located in Latin America, finally the principal component analysis, cluster and causal mapping for the strategy correction is done. In this research, a real case study has discovered with twelve failures modes and fourteen activities to avoid the design and construction mistakes, they should be considered to improve the international standards in the design of this important equipment for the power system. Furthermore, if in the analysis, the shunt reactor is full loading, all the fatigue fractures occur for a vibration in the shunt reactor with a partial discharge in the bushing connection and the spring closure of the equipotential devices. It results in a larger investigation with the new proposal, it is the root cause of one of the most critical points. These results indicated that re-evaluating shunt reactor design to ensure an optimal behavior with the components for this equipment in a full load stage.</p>

A Fault Analysis of 750kV Shunt Reactor and Repair Program

Internal Fault Diagnosis and Analysis of a 1000kV Shunt Reactor with Abnormal Ground Current of Iron Core and Clamp

Analysis of a 35kV vacuum circuit breaker accident caused by protection misoperation

Diagnosis and Analysis of Abnormal Heating Fault for 35kV Dry Air Core Reactor

Root cause analysis for shunt reactor failure in 500 kV power system

Incident Analysis of Excessive Acetylene from a 1000 Kv Shunt Reactor Due to Transient Operations

Mechanical & Thermal Stress Analysis under Actual Condition and Test Design of 550kv High Coupled Split Reactor

Noninvasive method for online detection of internal winding faults of 750 kV EHV shunt reactors

Maloperation Analysis and Preventive Measures of 500 kV Reactor Protection

The Partial Discharge Field Test of 1000kV Shunt Reactors

A New Method to Detect the Inter-Turn Short Circuit Fault of Dry-Type Air-Core Shunt Reactor

Analysis of a Dry-type Reactor Fault Based on COMSOL Thermal Field Simulation and High Frequency Pulse Oscillations

Fault Analysis and Treatment of Partial Discharge in 500 kV Transformer

An Identification Method of Single-phase Permanent Fault at Transmission Lines with Shunt Reactors

Study on overvoltage and insulation coordination of DC filter for ±800 kV UHVDC project from Xiangjiaba to Shanghai

An Adaptive Reclosure Scheme for Parallel Transmission Lines with Shunt Reactors

Application of Partial Discharge Critical Monitoring Technology in Internal Defect Detection of Ultra-high Voltage Reactors

Defect Treatment and Cause Analysis of DC Grounding Fault in 500kV Substation

Fault Analysis And Simulation Of Ground-Fault Accident On Transformer In 500 Kv Ac/Dc Grids

Analysis on Burning Failures with 110kv Dry-Type Reactors by Salinity Accumulation

A Detection Method for Slight Inter-Turn Short-Circuit Fault in Dry-Type Air-Core Shunt Reactors