Abstract:A reactor is an important piece of equipment used for reactive power compensation in power system and has a significant impact on the safe operation of power system. Thermal behavior is one of the main causes of reactor failures. For an accurate analysis of the thermal behavior of reactors, electromagnetic–thermal–fluid multi-physics coupling modeling is chosen. However, there is a huge difference in size between the overall structure of the reactor and its insulating material, which makes it difficult to perform mesh generation, resulting in dense mesh and significantly increased solution degrees of freedom, thus making the solution of the reactor’s multi-physics field model very time-consuming. To address this, this paper proposes a simplified processing method to accelerate the solution calculation of the reactor’s multi-physics model. This method calculates the equivalent turns of each encapsulate with parallel coils in the reactor, simplifying the encapsulate into a single-layer coil, thereby greatly reducing the division and solution degrees of freedom of the multi-physics model, and thus accelerating the simulation calculation. Taking a BKDCKL-20000/35 dry-type air-core shunt reactor as an example, the outer diameter of the coil is nearly 12,000 times bigger than the coil insulation, which is a huge size difference. Both refined models and simplified models are established. Compared to the simulation results of the detailed model, the simplified model demonstrates good accuracy; the maximum relative error of temperature is just 2.19%. Meanwhile, the computational time of the simplified model is reduced by 35.7%, which shows promising effectiveness and significant potential for applying the optimization design and operation prediction of dry-type air-core shunt reactors for enhanced thermal performance.

Dynamic Stability Analysis of High-Power DC Reactor for ITER Poloidal Field Converter

Fault Analysis and Fault-tolerant Design for Parallel Redundant Inverter Systems

Structural Integrity Analysis for Final Design of ITER Gas Fueling Manifold

Concept Design of Fusion Power Shutdown System for ITER

Research and Development of the High-Power High-Current Polodial Field Converter Module

Numerical Analyses of Electromagnetic Forces on the ITER Blanket Module Shield Block During Major Disruptions

Installation Design and Integration of Poloidal Field Converter Units for ITER

Electromagnetic compatibility analysis and design of ITER Poloidal Field converter unit

Full Scale Prototype Research and Development of the Iter Pf Converter Unit

A method of DC short-circuit analysis and thyristor determination for high power nuclear fusion converter

Analysis and verification of electrodynamic force, thermal stress and current sharing for CRAFT converter structure design

Analyses for Passive Safety of Fusion-Reactor During Ex-Vessel Loss-Of-Coolant Accident

Study on the Four Quadrants Operation of ITER Poloidal Field Converter System

Fault Analysis and Simulation of the Short Circuit in High-Power Fusion Magnet Power Supply

Fault analysis of plasma facing component mounts using multiphysics simulation

Review and analysis of the AC/DC converter of ITER coil power supply

Power Balance Investigation in Long-Pulse High-Performance Discharges with ITER-like Tungsten Divertor on EAST

Analysis of a Dry-type Reactor Fault Based on COMSOL Thermal Field Simulation and High Frequency Pulse Oscillations

Thermal Simulation and Analysis of Dry-Type Air-Core Reactors Based on Multi-Physics Coupling

Safety analysis of plasma anomaly consequences in fusion reactors

Function Analysis and Parameter Selection for Series Reactor of Modular Multilevel Converter