Abstract:ELM mitigation with multi-pulses of SMBI has been demonstrated in EAST tokamak in quasi-steady state over 3 seconds. The ELM frequenc y increasing factor with SMBI is about 5-10. The energy confinement is slightly degraded during the ELM mitigation. Intermittent small scale turbulence, generated by SMBI inside the pedestal r egion, prevents the formation of ELMs, or reduces the amplitude of the ELM, while large scale turbule nc is triggered by the mitigated ELM. The power deposition width ( λq ) is increased by a factor of 2 with SMBI. The peak heat load is reversed from the outer strike point to the striated heat flux ar e with multi-pulses of SMBI, while the total heat on the outer divertor plates remains nearly constant. The heat transferred from the OSP to the SHF increases with SMBI pulse length. A combination of SMBI and LHCD can offer a large possibility for the control of the power deposition on the divertor plates by changing I p, the LHCD power, and the parameters of SMBI including the gas pressure, the pulse length, and the frequency. I) Introduction One of the major challenges for the magnetic fusio n c mmunity is how to extract energy from the core plasma of the fusion reactor w ithout endangering the plasma facing components, in particular the divertor plates. For ITER, in order to not damage the divertor plates, the peak power load on the target plates is limited to 10MW/m in steady condition and 20MW/m in transient condition during Type-I Edge Localize d Modes (ELMs) [1, 2]. How to reduce the power flux density on the divertor plate s is a critical issue. Techniques could be used to reduce the power flux density on the struct u e such as: inclining of the target plate for increasing the effective area; expanding of the fie ld line flux into divertor; power radiation from particles through ionizing collisions and elec tron relaxation. The existing ELM control techniques are the following: Pellet pacing [3], Re sonance Magnetic Perturbation (RMP) [4] and other external perturbation fields [5]. The Sup ersonic Molecular Beam Injection (SMBI) is a new technique for the ELM mitigation. The ELM mitigation with single pulse of SMBI has been firstly achieved in HL-2A [6], then confir med in KSTAR [7]. We report here the experimental results in EAST tokamak showing a very promising and effective technique with SMBI and Lower Hybrid Current Drive (LHCD) for the control of heat deposition on the divertor plates, and the mitigation of large ELMs i n quasi-steady state.

Numerical Analyses of Electromagnetic Forces on the ITER Blanket Module Shield Block During Major Disruptions

Electromagnetic analyses and optimization for slit configuration of ITER blanket shield block

Divertor Power Deposition Control and ELM Mitigation with Supersonic Molecular Beam Injection in the EAST Tokamak

Overview of the Recent Study on ELM Mitigation Physics with Different External Actuators on HL-2A Tokamak

ITER blanket engineering challenges and solutions

Analysis and Optimization of Cooling Channels in ITER Blanket Module

Electromagnetic analysis of HCCB TBM-set during plasma major disruptions

Analysis of Weakly Ionized Ablation Plasma Flows for a Hypersonic Vehicle

Electromagnetic load evaluating and optimizing approach of the blanket system during VDEs considering halo current

Multiscenario Electromagnetic Load Analysis of Blanket and VV for CFETR

Progress on design and R&D of ITER FW/blanket

Preliminary electromagnetic analysis of the COOL blanket for CFETR

The effect of blanket system and port plugs on the harmonic components of error field and optimizing approach investigation

Fault analysis of plasma facing component mounts using multiphysics simulation

Electromagnetic Force Calculations for ITER GDC Electrodes Using Constraint Equations

Electromagnetic compatibility analysis and design of ITER Poloidal Field converter unit

A Systematic Coupled Approach For Electromagnetic Susceptibility Analysis Of A Shielded Device With Multilayer Circuitry

Electromagnetic and Thermal Analyses of Faraday Shield of Various Materials and Structures for an ICP Source

Electromagnetic disruption analysis of 2.45 GHz LHW antenna in EAST under different plasma configurations

Nuclear analysis and shielding optimisation in support of the ITER In-Vessel Viewing System design

Electromagnetic analysis on conceptual design of the EU DEMO EC equatorial laucher