Abstract:This study investigates the effects of boron nitride (BN) coating characteristics on the subsurface oxidation behavior of SiC/SiC composites in high‐temperature, water‐rich environments. Three types of coatings were examined: a crystalline stoichiometric BN, an amorphous BN, and a Si‐doped amorphous BN, the latter two containing 5–10 at% of oxygen and carbon. High‐resolution imaging and chemical analysis techniques were used to probe microstructural changes after oxidation at 1000°C for 1 or 12 h in flowing 20 vol% H2O, focusing on effects of coating thickness. Complementary chemical thermodynamic calculations and models for reaction‐ and transport‐controlled recession were used to interpret the experimental findings. Crystalline BN coatings produce open recession channels without forming borosilicate glass, a consequence of carbothermal reduction arising from C/CO produced through concomitant SiC oxidation. The combination of active oxidation and the relatively thick coatings in this system (ca. 1 μm) leads to a recession rate controlled by the intrinsic BN volatilization rate rather than the rate of gas transport. In contrast, amorphous coatings, both undoped and Si‐doped, readily oxidize to form borosilicate glasses that replace the BN. Broadly, the recession lengths increase with coating thickness. In the early stages, while the glass is boria‐rich and thus permeable to environmental oxidants, recession is controlled by the BN oxidation rate. As boria volatilizes, the silica concentration in the glass increases, eventually reaching the saturation limit and precipitating solid silica on the internal surfaces, essentially arresting further recession.

Microstructural evolution and oxide layer structure of Csf/SiBCN composites during oxidation at 1500 °C

Microstructure and oxidation behavior of SiOC coatings on C/C composites co-deposited with HMDS and TEOS by using CVD process

Formation and Oxidation Behavior of Mo-Si-B Composite Coatings with B-rich Interlayer Prepared by Slurry Sintering Method

Oxidation behavior of 3D SiCf/SiBCN composites at 800–1200 °C

Wet oxidation behavior of C/SiC–SiHf(B)CN composites at high temperature

Oxide Scale Microstructure and Scale Growth Kinetics of the Hot-Pressed SiBCN-Ti Ceramics Oxidized at 1500 °C

Influence of BN microstructure on oxidation of SiC/BN/SiC composites

Mechanical properties and microstructure evolution of KD‐SA SiCf/BN/SiC CMCs oxidized at different temperatures

Oxidation resistance of SiCf/SiC composites with a PyC/SiC multilayer interface at 500 °C to 1100°C

Oxidation behaviors of carbon fiber reinforced multilayer SiC-Si3N4 matrix composites

A comparative study on high temperature oxidation behavior of SiC, SiC-BN and SiBCN monoliths

Oxidation mechanism of Al–Si–SiC composite at elevated temperature

Study on the oxidation mechanism of Al-SiC composite at elevated temperature

The Degradation Behavior of C/Sic Composites in Complex Environment

Crystallinity dependence of high-temperature oxidation of silicoboron carbonitride monoliths

Mechanical properties and strengthening mechanism of SiCf/SiC mini-composites modified by SiC nanowires

Multi-composition Coating for Oxidation Protection of Modified Carbon-Bonded Carbon Fiber Composites

Thermal Protection and Dielectric Properties of Borosilicate Coatings for SiCf/SiC Composites Under High-Temperature Oxidation

Effects of pyrolysis temperatures on the oxidation behavior of PIP-processed SiCf/SiC composites

A Thick SiC-Si Coating Prepared by One-Step Pack Cementation for Long-Term Protection of Carbon/carbon Composites Against Oxidation at 1773 K

Effects of H-Bn/sic Ratios on Oxidation Mechanism and Kinetics of C/C-BN-SiC Composites