Abstract:This study investigates the effects of boron nitride (BN) coating characteristics on the subsurface oxidation behavior of SiC/SiC composites in high‐temperature, water‐rich environments. Three types of coatings were examined: a crystalline stoichiometric BN, an amorphous BN, and a Si‐doped amorphous BN, the latter two containing 5–10 at% of oxygen and carbon. High‐resolution imaging and chemical analysis techniques were used to probe microstructural changes after oxidation at 1000°C for 1 or 12 h in flowing 20 vol% H2O, focusing on effects of coating thickness. Complementary chemical thermodynamic calculations and models for reaction‐ and transport‐controlled recession were used to interpret the experimental findings. Crystalline BN coatings produce open recession channels without forming borosilicate glass, a consequence of carbothermal reduction arising from C/CO produced through concomitant SiC oxidation. The combination of active oxidation and the relatively thick coatings in this system (ca. 1 μm) leads to a recession rate controlled by the intrinsic BN volatilization rate rather than the rate of gas transport. In contrast, amorphous coatings, both undoped and Si‐doped, readily oxidize to form borosilicate glasses that replace the BN. Broadly, the recession lengths increase with coating thickness. In the early stages, while the glass is boria‐rich and thus permeable to environmental oxidants, recession is controlled by the BN oxidation rate. As boria volatilizes, the silica concentration in the glass increases, eventually reaching the saturation limit and precipitating solid silica on the internal surfaces, essentially arresting further recession.

A comparative study on high temperature oxidation behavior of SiC, SiC-BN and SiBCN monoliths

Formation and Oxidation Behavior of Mo-Si-B Composite Coatings with B-rich Interlayer Prepared by Slurry Sintering Method

Influence of BN microstructure on oxidation of SiC/BN/SiC composites

Microstructural evolution and oxide layer structure of Csf/SiBCN composites during oxidation at 1500 °C

Crystallinity dependence of high-temperature oxidation of silicoboron carbonitride monoliths

Oxidation behavior of 3D SiCf/SiBCN composites at 800–1200 °C

Study on the oxidation mechanism of Al-SiC composite at elevated temperature

Crystallization Behavior of Amorphous Si2bc3n Ceramic Monolith Subjected to High Pressure

Enhanced thermal shock resistance of BN-based composites sintered by hot-pressing with the introduction of nano oxides

Wet oxidation behavior of C/SiC–SiHf(B)CN composites at high temperature

Oxidation Behavior of the Si-B-X (X = Mo, Cr, or Ti) Alloys in the Temperature Range of 1000–1400 °C

Improved thermal shock and oxidation resistance of β-SiAlON incorporated with h-BN

Oxidation Behavior of SiC/SiC Composites in Air at High Temperature

Oxidation mechanism of Al–Si–SiC composite at elevated temperature

Oxidation behavior and kinetics of (Zr, Ti)(C, N)–SiC ceramics with enhanced oxidation resistance at 850 °C–950 °C

Effect of boronizing treatment on the oxidation resistance of Zr2(AlSi)4C5/SiC composite

Effects of H-Bn/sic Ratios on Oxidation Mechanism and Kinetics of C/C-BN-SiC Composites

The Effect of MoAlB Substitutions on the Oxidation Behavior of ZrB2-SiC Composites at 1600°C

Investigation of the oxidation mechanism of Si-Al2O3-fused mullite containing Ti2O3 composite

The oxidation resistance mechanism of SiC-B4C-xAl2O3 ceramics at 1400 °C in air atmosphere

Oxidation behavior of Ti-Nb-Mo-Al-Six refractory high entropy alloy at 1000°C