Abstract:ZrB2-SiC-Zr2Al4C5 multi-phase ceramics with uniform structure and high density were successfully prepared through the introduction of in situ synthesized Zr2Al4C5 into ZrB2-SiC ceramic via SPS at 1800 °C. A systematic analysis and discussion of the experimental results and proposed mechanisms were carried out to demonstrate the composition-dependent sintering properties, mechanical properties and oxidation behavior. The results showed that the in situ synthesized Zr2Al4C5 could be evenly distributed in the ZrB2-SiC ceramic matrix and inhibited the growth of ZrB2 grains, which played a positive role in the sintering densification of the composite ceramics. With increasing Zr2Al4C5 content, the Vickers hardness and Young's modulus of composite ceramics gradually decreased. The fracture toughness showed a trend that first increased and then decreased, and was increased by about 30% compared with ZrB2-SiC ceramics. The major phases resulting from the oxidation of samples were ZrO2, ZrSiO4, aluminosilicate and SiO2 glass. With increasing Zr2Al4C5 content, the oxidative weight showed a trend that first increased then decreased; the composite ceramic with 30 vol.% Zr2Al4C5 showed the smallest oxidative weight gain. We believe that the presence of Zr2Al4C5 results in the formation of Al2O3 during the oxidation process, subsequently resulting in a lowering of the viscosity of the glassy silica scale, which in turn intensifies the oxidation of the composite ceramics. This would also increase oxygen permeation through the scale, adversely affecting the oxidation resistance of the composites with high Zr2Al4C5 content.

Effect of boronizing treatment on the oxidation resistance of Zr2(AlSi)4C5/SiC composite

Isothermal Oxidation of Zr2[Al(Si)]4C5–SiC Composites at 1000–1300°C in Air

Formation and Oxidation Behavior of Mo-Si-B Composite Coatings with B-rich Interlayer Prepared by Slurry Sintering Method

Effect of Lu2O3 addition on the oxidation behavior of SiC-ZrB2 composite coating at 1500 °C: Experimental and theoretical study

Effect of Zr2Al4C5 Content on the Mechanical Properties and Oxidation Behavior of ZrB2-SiC-Zr2Al4C5 Ceramics

Effect of silicon/graphite ratio and temperature on oxidation protective properties of SiC/ZrB2–SiC coatings prepared by pack cementation

The Effect of MoAlB Substitutions on the Oxidation Behavior of ZrB2-SiC Composites at 1600°C

In Situ Synthesis, Mechanical Properties, and Oxidation Resistance of (sic+zrb2)/zr3[al(si)]4c6 Composites

Effect of the Y2O3 amount on the oxidation behavior of ZrB2-SiC-based coatings for carbon/carbon composites

A dense ZrB2-SiC-Si/SiC-Si coating to protect carbon/carbon composites against oxidation at 1773 K and 1973 K

Effect of the ZrB2 content on the oxygen blocking ability of ZrB2-SiC coating at 1973K

Study on the oxidation mechanism of Al-SiC composite at elevated temperature

ZrB2 particles reinforced glass coating for oxidation protection of carbon/carbon composites

Oxygen barrier capability of ZrB2-SiC coating at 1700 °C strengthened by film-forming treatment

High-Temperature Oxidation Resistance of ZrB2-SiC Ceramic Composites Prepared by Reactive Hot Pressing

The oxidation resistance mechanism of SiC-B4C-xAl2O3 ceramics at 1400 °C in air atmosphere

Oxidation protection of tri‐layer La2Zr2O7/Yb2Si2O7/SiC‐coated Cf/SiC composites at high temperature

Enhanced Oxidation Resistance of ZrB2‐SiC‐WC Composite Below 1800 °C

Oxidation of Short Carbon Fiber Reinforced Zrb2-Sic Ceramics under Atmospheric and Oxyacetylene Torch Conditions

Effects of Si3N4 and WC on the oxidation resistance of ZrB2/SiC ceramic tool materials

Enhancement of oxidation resistance at 1000–1400 °C of low carbon Al2O3–C refractories with pre-synthesized SiCnw/Al2O3