Abstract:High pressure can significantly increase the densification. Further, during the high pressure assisted sintering, the nucleation rate is increased due to reduced energy barrier and the growth rate is suppressed due to the decreased diffusivity. Thus high pressure enables the specimen to be fabricated with relatively lower temperature and shorter sintering period that assures to obtain dense nanocrystalline ceramics. Dense nanocrystalline BaTiO3 ceramics with uniform grain sizes of 60 and 30 nm, respectively, were obtained by pressure assisted sintering. The crystal structure and phase transitions were investigated by Raman scattering at temperatures ranging from -190 to 200 degrees C. The Raman results indicated that the evolution of Raman spectrum with grain size is characterized by an intensity decrease, a broadening of the line width, a frequency shift, and the disappearance of the Raman mode. With increasing temperature, similar to 3 mm BaTiO3 normal ceramics, the successive phase transitions from rhombohedral to orthorhombic, orthorhombic to tetragonal, and tetragonal to cubic were also observed in nanocrystalline BaTiO3 ceramics. In addition, when particle size is reduced to the nanoscale, one will find some unusual physical proper-ties in nanocrystalline ceramics, compared with those of coarse-grained BaTiO3 ceramics. The different coexistences of multiphase were found at different temperature. Especially, the ferroelectric tetragonal and orthorhombic phase can coexist at room temperature in nanocrystalline BaTiO3 ceramics. The phenomenon can be explained by the internal stress. The coexistences of different ferroelectric phases at room temperature indicate that the critical grain size for the disappearance of ferroelectricity in nanocrystalline BaTiO3 ceramics fabricated by pressure assisted sintering is below 30 nm

Crystallization Behavior of Amorphous Si2bc3n Ceramic Monolith Subjected to High Pressure

In Situ Formation of the TiCN Phase in SiBCN Ceramic Aerogels Enabling Superior Thermal and Structural Stability Up to 1800 °C.

High-pressure Synthesis of High-Performance Submicron-Sized Polycrystalline Β-Si3n4 Bulk Without Additives

High‐Pressure Synthesis of Amorphous Si3N4 and SiBN‐based Monoliths Without Sintering Additives

Comparative study on the microstructure evolution and crystallization behavior of precursor-derived and mechanical alloying derived SiBCN

Effect of High Pressure on Microstructure of Crystallizing Amorphous Nd9Fe85B6 Alloy

Crystallization of Bulk Amorphous Alloy (Fe40ni40p14b6)(96)ga-4 in Supercooled Liquid Region

Polyborosilazane‐Derived High Temperature Resistant SiBCNO

Synthesis and Characterization of Superconducting NbC Nanotubes

Characterization of the Interface Region During the Agglomeration of Silicon Nanocrystals in Silicon Dioxide

Thermal Shock Behavior of Si3N4/BN Fibrous Monolithic Ceramics

Crystallinity dependence of high-temperature oxidation of silicoboron carbonitride monoliths

Mechanical Properties of Si3N4/BN Fibrous Monolithic Ceramics at Elevated-Temperature

Nano-Phase and SiC–Si Spherical Microstructure in SiC/Al-50Si Composites Solidified under High Pressure

Characterization and Microstructural Evolution of Continuous BN Ceramic Fibers Containing Amorphous Silicon Nitride

Raman Studies of Nanocrystalline Batio3 Ceramics

Incorporation of Metallic Components Into a Structure of Titanium Carbonitride at Ultra-High Load and Temperature of Spark Plasma Sintering and at Different Compaction Pressures During Explosive Method

Effect of Annealing Conditions on Microstructural Development and Phase Transformation in Silicon Carbide

Creep Behavior of SiC Whisker-Reinforced Si3N4/BN Fibrous Monolithic Ceramics

The microstructural evolution, mechanical and dielectric properties of BNW/SiO2 ceramics

High Pressure Crystallization of Amorphous Al2O3-ZrO2 Ceramics