Abstract:The mechanically alloyed amorphous SiBCN powders were hot pressed at 1500, 1600, 1700, 1800, and 1900 °C under a pressure of 80 MPa in the nitrogen atmosphere for 30 min. The crystallization, the microstructural evolution, and the properties of the prepared ceramics were carefully studied by XRD, TEM, HRTEM, and property testing. Results show that the crystallization of β-SiC, turbostratic BN(C), and α-SiC in the amorphous matrix starts at about 1500, 1600, and 1700 °C, respectively. When the powder is hot pressed at the temperatures higher than 1700 °C, the prepared ceramics always consist of nano β-SiC, α-SiC, turbostratic BN(C), and amorphous body. With the increase of the sintering temperature, the ceramic crystallinity becomes higher, the grains get larger, and the amorphous content becomes lower. At the temperatures lower than 1800 °C, the bulk density, the relative density, the flexural strength, the Young’s modulus, and the fracture toughness of the prepared ceramics show persistent but insignificant increase. However, when the ceramic is sintered at 1,900 °C, these properties are rapidly improving to 2.6 g/cm3, 91.8 %, 331.0 MPa, 139.4 GPa, and 2.8 MPa m1/2.

Effect of Annealing Conditions on Microstructural Development and Phase Transformation in Silicon Carbide

Crystallization Behavior of Amorphous Si2bc3n Ceramic Monolith Subjected to High Pressure

Effect of annealing treatments on microstructure and mechanical properties of liquid-phase-sintered silicon carbide

Effect of High Pressure Annealing on Electrical Properties of Nitrogen and Germanium Doped Silicon

The Effect of Annealing Temperature on Micro-Structure and Mechanical Properties of C/Sic Composites

Influence of High Pressure Annealing on Electrical Properties of Surface Layer of Neutron Irradiated or Germanium-Doped Czochralski-Grown Silicon

Effect of Heat Treatment on Carbon in Multicrystalline Silicon

Microstructure Evolution and Precipitation of SiC Particle Reinforced Al–20Si Composite Solidified under High Pressures

Influence of annealing on microstructures and photoluminescence of nano-composite silicon film

Nano-Phase and SiC–Si Spherical Microstructure in SiC/Al-50Si Composites Solidified under High Pressure

Gas Pressure Atmosphere Annealing: A Novel Method for the Preparation of SiC Nanowires

Study on Phase Transformation and Microstructure Development of Yb Α-Sialon Ceramics Prepared by Pressureless Sintering

Investigation of the effect of pressure, sintering temperature and time on silicon carbide microstructure

Effect of annealing time on the structure and conductivity of amorphous polycarbosilane-derived silicon carbide ceramics

Effects of high pressure and SiC content on microstructure and precipitation kinetics of Al-20Si alloy

Study on the Performance for Silicon Carbide Ceramics by Hot-pressing Sintering

Study of SiC/Al nanocomposites under high pressure

Crystallization and Microstructural Evolution Process from the Mechanically Alloyed Amorphous SiBCN Powder to the Hot-Pressed Nano SiC/BN(C) Ceramic

Microstructural Evolution of Amorphous Si2BC3N Nanopowders Upon Heating at High Temperatures: High Pressures Reverse the Nucleation Order of SiC and BN(C)

Microstructural Evolution and Mechanical Properties of SiC/Al-40Si Composites Fabricated by High Pressure Solidification.

Effect Of Aln Content On The Pressureless Sintering Behaviors Of Sic-Aln Multiphase Ceramics