Abstract:C/Cx-SiCy composites are one of the most promising counterparts of C/C composites as they maintain the mechanical strength of C/C composites while providing excellent anti-ablation properties at the same time. This paper reports that the composites could exhibit even better anti ablation properties after heat treatment. The materials were heat-treated and then tested with a thin-blade oxyacetylene torch without the protection of any coatings. The 1600 °C heat-treated thin-blade specimen could sustain the ablation of the oxyacetylene torch with a temperature of 1776 °C (80 °C higher than the original material without heat treatment) and a lower liner ablation rate (1.31 μm/s) than the original material (1.66 μm/s). An extreme ablation test was also conducted at around 2400 °C, and the 1600 °C heat-treated specimen exhibited a lower linear ablation rate (13 μm/s) than the original specimen (47 μm/s). The influence of the heat treatment on the crystallinity of the matrix is studied with the additional help of Raman spectroscopy and XPS. The ablation mechanism is discussed in detail, and the fluent condition of the thin-blade specimen is simulated. The paper also reports a different ablation behavior of the 1600 °C heat-treated specimen from the material without heat treatment to explain their excellent ablation property.

Ablation behavior of mullite modified C/C-SiC-HfC composites under oxyacetylene torch for single and cyclic ablations with two heat fluxes

Cyclic ablation behavior of mullite-modified C/C-HfC-SiC composites under an oxyacetylene flame at about 2400 °C

Comparison of the ablation resistance of mullite modified C/C-SiC-HfC and C/C-SiC-HfC composites under oxyacetylene flame of 2.38 MW/m 2 heat flux

Cyclic ablation behaviors of mullite‐modified C/C–ZrC–SiC composites prepared by PIP

Effect of mullite content on microstructure and ablation behavior of mullite modified C/C-SiC-HfC composites

Ablation behavior of C/C–Zr1-xHfxC-SiC composites under an oxyacetylene flame at above 2500 °C

Cyclic ablation behavior of C/C–ZrC–SiC composites under oxyacetylene torch

Ablation behavior and mechanisms of 3D-Cf/Ta0.8Hf0.2C-SiC composite at temperatures up to 2500 °C

Ablation behavior and mechanisms of ZrC-SiC-MoSi2 coated C/C-SiC-ZrC ceramic matrix composites under oxyacetylene torch

Ablation behavior of 3D PyC-Cf/SiHfBOC Composites under an oxyacetylene torch environment above 2000 °C

Ceramic Matrix Composite Cyclic Ablation Behavior under Oxyacetylene Torch

Ablation behavior of nose-shaped HfB2-SiC modified carbon/carbon composites exposed to oxyacetylene torch

Microstructure and ablation behavior of C/C–HfC–SiC composites fabricated by reactive melt infiltration with Hf–Si alloy

The influence of heat treatment on the ablation behavior of the C/Cx-SiCy composites tested by thin-blade under oxyacetylene torch

Ablation Mechanism of AlSiB-C/C Composites under an Oxy-Acetylene Torch

Ablation performance of C/C-ZrC-SiC composites with in-situ YSi 2 -doped ZrC-SiC-ZrSi 2 coating under oxyacetylene torch

Ablation behavior and mechanisms of Cf/(Ti0.2Zr0.2Hf0.2Nb0.2Ta0.2)C–SiC high-entropy ceramic matrix composites

Long-term ablation mechanisms of the YB4-Al2O3-Si3N4 modified Cf/HfC-SiC composites at 2600 °C

Ablation behavior of Cf/ZrC-SiC and Cf/SiC composites produced by precursor infiltration and pyrolysis combined with gaseous silicon infiltration

Ablation behaviors and mechanisms of Cf/HfCPIP-SiCCVI composites: From SiO2 nanowires film to HfO2 skeleton

Ablation mechanism of Cf/(Ti0.2Zr0.2Hf0.2Nb0.2Ta0.2)C-SiC composite during plasma ablation above 2000 °C