Abstract:Additive manufacturing (AM) of metal usually forms columnar grains along the building direction due to the focused thermal energy directly heating the deposition layer to easily obtain an obvious temperature gradient. The columnar grains are not conducive to AM-sample application, which results in the property anisotropy of the AM-sample. In this work, a novel directed energy deposition-arc (DED-Arc) method for depositing layers without direct heating by focused thermal energy is proposed. The arc burns between the tungsten electrode and a water-cooled electrode, were only used to melt the wire during DED-Arc process. Using stainless steel wire as a model alloy, by studying droplet transfer, morphology of the deposition layer and microstructure evolution, the feasibility of the method was fully verified. Two kinds of droplet transfer modes were observed, and the difference between them was whether the droplet contacted the molten pool before falling off. The focused thermal energy is only used to melt the wire, and the droplet transfer cycle is mainly affected by gravity, greatly decreasing the heat accumulation compared with existing methods. The heat-affected zone (HAZ) was obviously inhibited. The grain morphology of the deposition layer mainly consists of equiaxed crystals (∼300μm) without an obvious preferred orientation. The deposition layer without direct heating by focused thermal energy could reduce the heat accumulation, resulting in a decrease in the temperature gradient and the morphology of equiaxed grains. The microstructure of a cylindrical sample was produced and has the same characteristics as with the deposition layer. The average microhardness of 172.63 HV, 167.95 HV and 169.26 HV are obtained in the top, middle and bottom regions, respectively. In addition, the tensile strengths are 500MPa and 490MPa, respectively.

Additive manufacturing of tungsten using directed energy deposition for potential nuclear fusion application

Microstructure and thermal properties of unalloyed tungsten deposited by Wire + Arc Additive Manufacturing

Simulation and Experimental Investigation on Additive Manufacturing of Highly Dense Pure Tungsten by Laser Powder Bed Fusion

Vacuum Hot-Pressed Beryllium and Tic Dispersion Strengthened Tungsten Alloy Developments for Iter and Future Fusion Reactors

Tungsten Joining with Copper Alloy and Its High Heat Load Performance

Achieving high-performance pure tungsten by additive manufacturing: Processing, microstructural evolution and mechanical properties

Microstructure and fracture behavior of 90W-7Ni-3Fe alloy fabricated by laser directed energy deposition

Ultra-fine Grained/Nano-crystalline Tungsten-Plasma Facing Material for Future Fusion Reactors

Dense Pure Tungsten Fabricated by Selective Laser Melting

Research and Development of Alloy Modified Tungsten-based Materials

Additive manufacturing of 316L stainless steel by electron beam melting for nuclear fusion applications

Development of Wire + Arc Additive Manufacturing for the production of large-scale unalloyed tungsten components

Fabrication of High-Density Microarchitected Tungsten via DLP 3D Printing

Advances in Laser Powder Bed Fusion of Tungsten, Tungsten Alloys, and Tungsten-Based Composites

Effects of laser printing parameters on molten pool formation, microstructure evolution and mechanical properties of laser directed energy deposition of difficult-to-process tungsten heavy-alloy

A hybrid directed energy deposition process to manipulate microstructure and properties of austenitic stainless steel

Two optimized post-heat treatments to achieve high-performance 90W–7Ni–3Fe alloys fabricated by laser-directed energy deposition

Selective Laser Melting of High-Performance Pure Tungsten: Parameter Design, Densification Behavior and Mechanical Properties

A novel directed energy deposition-arc method of deposition layer without focused thermal energy heating: droplet transfer, morphology and microstructure

Application of Tungsten as a Plasma-facing Material in Nuclear Fusion Reactors

Densification, microstructural evolutions of 90W-7Ni-3Fe tungsten heavy alloys during laser melting deposition process