Abstract:In the current study, a 3-D microscopic structural finite element (FE) model of interpenetrating SiC/Al composites (SiC/Al IPCs) is built, based on X-ray tomography and optimized methods for 3-D mesh generation. In addition, an interface model is introduced into the 3-D FE model to investigate the effects of the interfaces on the damage and failure processes, which includes a “tie-break contact” method at the SiC/Al interfaces. Subsequently, FE methods are applied to investigate the dynamic compression response of the 3-D FE model. To validate the numerical simulation results, the dynamic compression responses of SiC/Al IPCs are measured at strain rates of 2000s−1 using a split Hopkinson pressure bar device. Our results show that failure of the SiC phase occurs just before the effective stress reaches its peak, but it plays a leading role in bearing the pre-metaphase stage of the load. From the point of energy dissipation, however, the contribution of Al phase cannot be ignored in the final stage of failure because the residual Al phase absorbs 30% of the energy of the global model by plastic deformation, even though its mass failure ratio is only 2%. Further microanalysis shows that the cracks initiate and propagate mainly near the SiC/Al interface, just on the side of the SiC ceramic phase. As the cracks extend further into the SiC phase, there appears a new “interface debonding” failure mode. These results show that brittle fracture of the SiC ceramic phase plays a key role in crack initiation, since the presence of complex 3-D SiC/Al interfaces usually causes the generated cracks to deflect before interconnecting with each other. This significantly retards propagation of the cracks, and thus increases the ductility of the composite materials. In the final stage of failure, the cracks are interconnected with each other in the SiC phase while the Al phase still maintains a degree of structural integrity. It is found that there exists obvious plastic deformation in local, relatively narrow, regions in the Al phase, and the local necking and tearing fractures tend to be localized in these severely deformed regions. Numerical simulation results are consistent with the observed behavior.

Analysis of Multi-scale Failure Behavior of SiC f /SiC Composite Clad Tube under Flexible Clamping Damage

Multi-scale Progressive Damage and Failure Behavior Analysis of Three-Dimensional Winding SiC Fiber-Reinforced SiC Matrix Composite Tube

In-situ Observation of Damage Evolution in Mo-SiCf/SiC Heterogeneous Composite

Multi-scale Pore Model Construction and Damage Behavior Analysis of SiCf/SiC Composite Tubes

Modeling of the damage and fracture behaviors of a SiC triplex tube during the burst test with elastomeric insert

Multiscale Failure Mechanism Analysis of SiC Fiber-Reinforced TC17 Composite Subjected to Transverse Tensile Loading at Elevated Temperature

Analysis of the Damage Initiation in a SiC/SiC Composite Tube from a Direct Comparison Between Large-Scale Numerical Simulation and Synchrotron X-ray Micro-Computed Tomography

An Efficient Multi-Scale Method for Failure Mechanism Analysis of SiCf/Ti Composites with Experimental Validation

Application and Analysis of Plane Woven C/Sic Composites Based on Continuum Damage Mechanics

Simulation of Damage and Failure Processes of Interpenetrating SiC/Al Composites Subjected to Dynamic Compressive Loading

Damage and failure analysis of a SiCf/SiC ceramic matrix composite using digital image correlation and acoustic emission

Multiscale Modeling of SiCf/SiC Nuclear Fuel Cladding Based on FE-Simulation of Braiding Process

In situ high-temperature 3D imaging of the damage evolution in a SiC nuclear-fuel cladding material

Internal Damage Evolution Investigation of C/SiC Composites Using In-Situ Tensile X-ray Computed Tomography Testing and Digital Volume Correlation at 1000 °C

Fracture behavior of SiC f /SiC cladding with prefabricated cracks on the inner/outer wall

Cross-scale Static/dynamic Shear Damage Evolution Mechanism of 2D C/SiC Ceramic Matrix Composite with Transient Hysteresis Effect

Characterisation of damage evolution in plain weave SiC/SiC composites using in situ X-ray micro-computed tomography

Damage Analysis of a SiCf/SiC Ceramic Matrix Composite under Stepwise Fatigue Loading with Acoustic Emission

Tensile Damage Evolution and Mechanical Behaviour of SiCf/SiC Mini-Composites Through 4D In-Situ Micro-Ct and Data-Driven Modelling

Experimental investigation of probabilistic failure of SiC/SiC composite tubes under multiaxial loading

Radial Compressive Mechanical Behavior of 2D Plain‐Woven SiCf/SiC Cladding Tube