Abstract:Monocrystalline silicon wafer is the most important raw material in chip manufacturing; wire sawing is the most common processing method of monocrystalline silicon wafer. The residual stress generated by cutting affects the subsequent polishing costs directly, as well as the fracture strength and mechanical integrity of the monocrystalline silicon wafer, thus affecting the service performance. In this paper, the generation mechanism of residual stress was analyzed based on diamond wire sawing technology. Then, based on Drucker-Prager (D-P) plastic constitutive model, the magnitude and distribution of residual stress of monocrystalline silicon chip under different process parameters were simulated by ABAQUS simulation software. Finally, the experiment of ultrasonic vibration–assisted diamond wire saw cutting monocrystalline silicon was conducted, and the residual stress of monocrystalline silicon chips were detected by blind hole method. During the detection, the strain values before and after drilling in three directions of monocrystalline silicon chips were measured by strain gauge rosette, and then the residual stress values were determined according to the strain values and the residual stress calculation theory. The experimental results showed that residual compressive stress remains on the surface of silicon wafer in both conventional wire sawing and ultrasonic vibration–assisted wire sawing. The residual compressive stress increases with the increase of the axial speed of wire saw, decreases with the increase of the wire saw feed speed, and fluctuates with the increase of the workpiece rotation speed. The residual compressive stress on the surface of the silicon wafer by ultrasonic vibration–assisted wire sawing is larger than that by conventional wire sawing. The simulation and experimental results have the same trend, which verifies the validity of the finite element model in this paper and provides theoretical support for the subsequent processing of single crystal silicon.

Measurement and analysis of residual stress in the body of silicon carbide mirror during optical fabrication

X-ray stress measurement of SiC single-crystal induced by laser ablation

Thermal Stress and Displacement in Process of Producing CVD-SiC Mirror

Study of Local Stress Using Stress-Absorbing Si Diaphragm

Generation and distribution of residual stress during nano-grinding of monocrystalline silicon

The surface residual stress of monocrystalline silicon in ultrasonic vibration–assisted diamond wire sawing

Flatness Maintenance and Roughness Reduction of Silicon Mirror in Chemical Mechanical Polishing Process

X-ray Diffraction Analysis of Damaged Layer During Polishing of Silicon Carbide

Internal Stress Measurement of LPCVD Silicon Nitride Deposited on Different Substrates

Microstructure Modulation of Silicon Planted Glass with Low Mirror Reflection

Residual Stress in Sputtered Silicon Oxycarbide Thin Films

Study of Residual Stress Compensation in Continuous Membrane Micromirrors Based on Surface Micromachining Processes

Residual Stress Measurement of Single-Crystal SiC with Different Crystallographic Orientations

Evaluation of Residual Stress in MEMS Micromirror Die Surface Mounting Process and Shock Destructive Reliability Test

Investigation of the Young's Modulus and the Residual Stress of 4H-SiC Circular Membranes on 4H-SiC Substrates

Origins and characterization techniques of stress in SiC crystals: A review

Measurement of Young's modulus and residual stress of silicon microstructures

On the Fracture Toughness Measurement of Thin Film Coated Silicon Wafers

Towards Investigating Surface Quality of Single-Crystal Silicon Optics Polished with Different Processes

Effects of interfacial residual stress on mechanical behavior of SiCf/SiC composites

Grinding of silicon carbide for optical surface fabrication, Part 1: surface analysis