Abstract:Various defects during the manufacture of a high-energy laser monocrystalline silicon reflector will increase the energy absorption rate of the substrate and worsen the optical properties. Micron-scale or larger manufacturing defects have been inhibited by mechanism study and improvement in technology, but the substrate performance still fails to satisfy the application demand. We focus on the changes in the optical properties affected by nanoscale and Angstrom lattice defects on the surface of monocrystalline silicon and acquire the expected high reflectivity and low absorptivity through deterministic control of its defect state. Based on the first principles, the band structures and optical properties of two typical defect models of monocrystalline silicon—namely, atomic vacancy and lattice dislocation—were analyzed by molecular dynamics simulations. The results showed that the reflectivity of the vacancy defect was higher than that of the dislocation defect, and elevating the proportion of the vacancy defect could improve the performance of the monocrystalline silicon in infrared (IR) band. To verify the results of simulations, the combined Ion Beam Figuring (IBF) and Chemical Mechanical Polishing (CMP) technologies were applied to introduce the vacancy defect and reduce the thickness of defect layer. After the process, the reflectivity of the monocrystalline silicon element increased by 5% in the visible light band and by 12% in the IR band. Finally, in the photothermal absorption test at 1064 nm, the photothermal absorption of the element was reduced by 80.5%. Intense laser usability on the monocrystalline silicon surface was achieved, and the effectiveness and feasibility of deterministic regulation of optical properties were verified. This concept will be widely applied in future high-energy laser system and X-ray reflectors.

Microstructure Modulation of Silicon Planted Glass with Low Mirror Reflection

Coating of glass with low reflection Si nanofilm

Effect of annealing on microstructure and photoluminescence of nano-composite silicon film

Influence of C_2H_4 on the Properties of Amorphous Silicon Film Grown by Chemical Vapor Deposition

Influence of annealing on microstructures and photoluminescence of nano-composite silicon film

Microstructure and Conductivity of Large Area Nanocrystalline Silicon Films Grown by Specially Designed Thermal-Assisted Chemical Vapor Deposition

Novel Sandwich Structure for Aluminum Induced Crystallization of Amorphous Silicon Thin Films at Low Temperature

The Effects of Microstructure on Optical and Thermal Properties of Porous Silica Films

Effects of Coating Methods on Microstructure and Optical Properties of Mesoporous Silica Films

Preparation and Photoluminescence of Nanocrystalline Si-Rich Silicon Oxide Films by Pecvd

Micro/nano structure size effect on superhydrophobicity and anti reflection of single crystalline Si solar cells

Research on Mechanism for High Light Absorption of Micro-Structured Silicon

Research on ultra-smooth machining technique for monocrystalline silicon substrate

Modulation Effect of Microstructures in Silicon-Rich Oxide Matrix on Photoluminescence from Silicon Nanoclusters Prepared by Different Fabrication Techniques

Microstructures and Characteristics of Nanosize Crystalline Silicon Films

Flatness Maintenance and Roughness Reduction of Silicon Mirror in Chemical Mechanical Polishing Process

Comparative Study on Microstructure of Mo/Si Multilayers Deposited on Large Curved Mirror with and without the Shadow Mask

Simulation and Experimental Study on Anti-reflection Characteristics of Nano-patterned Si Structures for Si Quantum Dot-Based Light-Emitting Devices

Enhancement of the Load Capacity of High-Energy Laser Monocrystalline Silicon Reflector Based on the Selection of Surface Lattice Defects

Silicon lattice layer regulation: A close-to-atomic-scale method for optimizing infrared optical properties

A New Method Used to Control the Structure of High Rate Microcrystalline Silicon Thin Films