Abstract:For the battery- or USB-powered portable smart devices, which supply their computing cores with a wide-range sub-volt rail, the energy-efficient high and wide voltage-conversion-ratio (VCR) converters are crucially important. In addition, low form factor and decent transient responses are also favorable for such applications. Prior state-of-the-art designs either use single-stage hybrid designs using multi-level or Dickson converters [1 – 3], or adopt two-stage cascaded architectures with a highly efficient unregulated front (or rear) stage [4], as shown in Fig. 18.6.1 (left). The multi-level designs, which conduct the full inductor current through all the on-state switches, are suited to low-to-medium power levels with limited current density. The Dickson converters take advantage of a high conversion ratio, however, at the cost of reduced output voltage range. The two-stage designs which show decent output range and efficiency, however, can suffer from heavy load efficiency degradation considering that the efficiency of both stages degrade with increasing load and the overall efficiency which is the product of the efficiencies of the two stages is severely degraded. Inspired by the inductive-sigma converter [5] which shunts a highly efficient unregulated LLC with a regulated Buck, this work proposes a reconfigurable capacitive-sigma converter. By input-series and output-shunting a highly efficient unregulated switched-capacitor (SC) converter with a reconfigurable Dickson hybrid Buck stage, the power stage input current is reused and output currents are combined. Therefore, the overall efficiency is greatly improved in a wide continuous VCR range and with an enhanced loading capacity. Besides, as will be demonstrated, the proposed design shows inherently decent load transient and regulation performances.

Reconfigurable mode converter based on a Sb_2Se_3 phase change material and inverse design

On-Chip Reconfigurable and Ultracompact Silicon Waveguide Mode Converters Based on Nonvolatile Optical Phase Change Materials

Inverse design of compact nonvolatile reconfigurable silicon photonic devices with phase-change materials

Design of a Non-Hermitian On-Chip Mode Converter Using Phase Change Materials.

Reconfigurable inverse designed phase-change photonics

A New Family Of Soft-Switching Phase-Shift Bidirectional Dc-Dc Converters

Reversible Thermally Driven Phase Change of Layered In2Se3 for Integrated Photonics.

Tunable On-Chip Mode Converter Enabled by Inverse Design

Nonvolatile Electrically Reconfigurable Silicon Photonics Enabled by Back-End-of-line Integration of Phase Change Materials

Optimized wideband and compact multifunctional photonic device based on Sb_2S_3 phase change material

Chalcogenides Phase Change Materials for PICs

Low-loss and compact arbitrary-order silicon mode converter based on hybrid shape optimization

Multimode Signal Processor Unit Based on the Ambipolar WSe2-Cr Schottky Junction

Three-Terminal Probe Reconfigurable Phase-Change Material Switches

Low Resistance, High Dynamic Range Reconfigurable Phase Change Switch for Radio Frequency Applications

Non‐Volatile Optical Switch Element Enabled by Low‐Loss Phase Change Material

A 5V Input 98.4% Peak Efficiency Reconfigurable Capacitive-Sigma Converter with Greater Than 90% Peak Efficiency for the Entire 0.4~1.2V Output Range.

Reconfigurable InSe Electronics with van der Waals Integration

Reconfigurable Dielectric Engineered WSe 2 /HZO Mem-transistor

Multi-mode conversion via two-dimensional refractive-index perturbation on a silicon waveguide

Mode converter based on an inverse taper for multimode silicon nanophotonic integrated circuits.