Abstract:Zirconia‐toughened alumina (ZTA) ceramics with high mechanical properties were sintered by hot‐pressing method using SiC particles (SiCp) and SiC whiskers (SiCw) as the reinforcing agents simultaneously. The influences of sintering temperature, SiCp and SiCw contents on the microstructure and mechanical properties of ZTA ceramics were investigated. It was found that both SiCp and SiCw could contribute to grain refinement significantly and promote the mechanical properties of the ceramics. However, the excess addition of SiCp or SiCw led to the formation of pores with large sizes and degraded the mechanical properties instead. When 13 wt% SiCp was introduced, the maximum flexural strength of 1180.0 MPa and fracture toughness of 15.9 MPa·m1/2 were obtained, whereas the maximum flexural strength of 1314.0 MPa and fracture toughness of 14.7 MPa·m1/2 were achieved at 20 wt% SiCw. Interestingly, the simultaneous addition of SiCp and SiCw could further improve the mechanical properties, and the highest flexural strength of 1334.0 MPa and fracture toughness of 16.0 MPa·m1/2 were achieved at a SiCw/SiCp ratio of 16/4. The reinforcement mechanisms in the ceramics mainly included the phase transformation toughening of ZrO2, the crack deflection and bridging of SiCp and SiCw and the pull‐out of SiCw.

Strengthening mechanism of Al2O3–ZrO2–C sliding plate material by existence modes of in-situ generated β-SiC whiskers

Wear Behaviour and Microstructural Changes of SiCw-Al Composite under Unlubricated Sliding Friction

Improvement of mechanical properties of Al2O3/Ti3SiC2 multilayer ceramics by adding SiC whiskers into Al2O3 layers

Synergistic Toughening Effect of SiC Whiskers and Particles in ZrO2–Al2O3–SiC Ceramics

Mechanical and Tribological Properties of SiC Whisker‐reinforced SiC Composites Via Oscillatory Pressure Sintering

Mechanical and tribological properties of SiC whiskers reinforced SiC composites via oscillatory pressure sintering

Ablative properties of laminated ZrB2-SiC ceramic modified by SiC whisker in oxyacetylene environment

Fabrication and characterization of SiC whisker reinforced reaction bonded SiC composite

Role of nano-Al2O3 particles in improving the properties of MgO–C slide plate materials

Microstructure and fracture behaviour of ZrO2 (2 mol% Y2O3) reinforced with SiC whiskers

Microstructure, Mechanical and Tribological Properties of CrSiC Coatings Sliding Against SiC and Al2O3 Balls in Water

Fabrication of toughened Cf/SiC whisker composites and their mechanical properties

Improved thermal shock stability and oxidation resistance of low-carbon MgO–C refractories with introduction of SiC whiskers

Mechanical Properties of SiC-Whisker-Reinforced MoSi<sub>2</sub> Composites

Microstructure, mechanical and friction-wear properties of SiC-WC composite with Al and C as sintering aids

Properties and microstructure evolution of unfired Al–Si incorporated Al2O3–C slide plate materials with trace nano-Al2O3 particles

Preparation, mechanical properties, and toughening mechanisms of SiCw/SiCp‐reinforced zirconia‐toughened alumina ceramics

Preparation and mechanical properties of SiC whisker-reinforced alumina

Microstructure And Fracture Behaviour Of Zro2 (2 Mol% Y2o3o) Reinforced With Sic Whiskers

Fabrication and Abrasive Wear Behavior of ZrO2-SiC-Al2O3 Ceramic

Preparation and Mechanical Properties of SiC Whisker and Nanosized Mullite Particulate Reinforced TZP Composites