Utilization of coal mine gas in solid oxide fuel cells: A performance evaluation

E.V. Tsipis,A.U. Sharafutdinov,D.V. Matveev,M.S. Dyakina,D.V. Zhigacheva,D.V. Yalovenko,A.P. Paduchev,S.I. Bredikhin,V.V. Kharton

DOI: https://doi.org/10.1016/j.jpowsour.2023.233834

IF: 9.2

2024-01-01

Journal of Power Sources

Abstract:The possibility and regimes of coal mine gas utilization in solid oxide fuel cells (SOFCs) without external methane reforming were appraised using a short-stack of two membrane-electrode assemblies with the planar electrolyte-supported architecture. The stack fueled by model coal mine gas, namely 59 % CH4 - 5 % CO2 – 36 % N2 mixture humidified at 343–363 K, demonstrated a stable operation during approximately 170 h at 1123 K when the fuel humidity was higher than 38 vol%. The performance decreased with increasing steam concentration and was lower than that obtained for hydrogen fuel at the same humidity levels. The maximum power density, 157 mW/cm2 at the current density of 284 mA/cm2, was observed for 38 % humidity close to the thermodynamic limit where carbon nanotube formation may start at the SOFC anode. Decreasing water vapor partial pressure resulted in a fast degradation, accompanied with increasing ohmic and polarization losses. Subsequent microscopic analysis confirmed that these effects are indeed associated with the carbon deposition. Beyond the coking domain, the current vs. voltage dependencies of the SOFC stack can be described by a simplified model assuming that the anode kinetics is essentially governed by the electrochemical oxidation of hydrogen.

energy & fuels,materials science, multidisciplinary,electrochemistry,chemistry, physical