Abstract:Solid oxide fuel cell (SOFC) provides a new method for clean and efficient conversion and utilization of hydrocarbon fuels due to its high fuel flexibility. The utilization of biogas fuel through direct internal reforming (DIR) allows for a simplification of the SOFC system since no external reformer appears strictly necessary. Despite its considerable convenience and potential, at present, direct internal dry reforming is still not considered as a competitive process for commercial application, which is limited by the reaction difficulty and high risk of carbon deposition. To address the problem, in this study, conventional Ni-yttrium stabilized zirconia (YSZ) anodes of SOFCs are modified by two methods, i.e. Ce0.9Gd0.1O2-δ (GDC) infiltration and a Ni-GDC reforming catalytic layer. A comparative study between the modified cells and the bare cell is made under operation with humidified H2 and simulated biogas. Both of these two modification methods lead to a slight but acceptable decrease of the cell performance under humidified H2. In the case of simulated biogas, results show that GDC infiltration is only beneficial to the cell performance with very low or very high CO2/CH4 molar ratio. While with a moderate CO2/CH4 ratio of 0.5–1.5, GDC infiltration instead results in a decrease of cell performance. However, the cell modified by a Ni-GDC catalytic layer shows superior performance towards the direct utilization of simulated biogas than the bare one and the one modified by GDC infiltration. The anode modification by a Ni-GDC catalytic layer can also improve the stability of the cell under simulated biogas, which is verified under different operating currents, although serious carbon deposition is detected in the catalytic layer afterwards.

Performance of Solid Oxide Fuel Cells on H-2, Nh3 and Hydrocarbon Fuels

Theoretical Electromotive Force and Performance of SOFC Fed with Different Fuel Gases

Anode Catalysts for Solid Oxide Fuel Cells That Run Directly on Hydrocarbon Fuels

Progress in Solid Oxide Fuel Cells with Hydrocarbon Fuels

Direct liquid methanol-fueled solid oxide fuel cell

Performance of solid-oxide fuel cells operating with different sustainable fuel reformates

Comparative study on the performance of a SDC-based SOFC fueled by ammonia and hydrogen

Comparison of a solid oxide cell with nickel/gadolinium‐doped ceria fuel electrode during operation with hydrogen/steam and carbon monoxide/carbon dioxide

Anode Performance of Mn-doped Ceria–scsz for Solid Oxide Fuel Cell

Performance Evaluation of Solid Oxide Fuel Cell with In-Situ Methane Reforming

Modeling of Direct Carbon Solid Oxide Fuel Cells with H2o and Co2 As Gasification Agents

Electrochemical Characteristics and Carbon Tolerance of Solid Oxide Fuel Cells with Direct Internal Dry Reforming of Methane

Low Temperature Solid Oxide Fuel Cells with Hierarchically Porous Cathode Nano-Network

Experimental and Modeling Study of High Performance Direct Carbon Solid Oxide Fuel Cell with in Situ Catalytic Steam-Carbon Gasification Reaction

Solid Oxide Fuel Cells Fueled by Simulated Biogas: Comparison of Anode Modification by Infiltration and Reforming Catalytic Layer

A High-Performance Ammonia-Fueled Solid Oxide Fuel Cell

High Performance Tubular Solid Oxide Fuel Cells With Bscf Cathode

The Performance of Solid Oxide Fuel Cells Based on Methanol Solution

Co-Generation of Electricity and Chemicals via Solid Oxide Fuel Cells Using Li-Doped LSGM and LSF Composite Anodes

Solid Oxide Fuel Cell Anode Materials for Direct Hydrocarbon Utilization

Influences of Hydrogen-Natural Gas Mixtures on The Performance of an Internal Reforming Solid Oxide Fuel Cell Unit: A Simulation Study