Abstract:Direct internal dry reforming is a promising way for solid oxide fuel cells (SOFCs) to directly use hydrocarbon fuels, since biogas already contains carbon dioxide and methane, which are both greenhouse gas contributing to global warming. In this paper, detailed experimental investigation and thermodynamic calculation were carried out to investigate the influence of CO2 addition on fuel cell's electrochemical characteristics and stability using CO2 to CH4 ratio ranging from 0 to 3. The maximum power densities were obtained at CO2 to CH4 ratios of 1.5 and 1.7 for fuel gas mixture with and without N-2 carrier gas, respectively. These two values are very close to thermodynamic calculation results about non-carbon limit. An analysis of distribution of relaxation time (DRT) for SOFC operated under dry reforming gas mixtures was first proposed in this study. The results show that the addition of CO2 can significantly reduce both the anode activation polarization and the fuel gas diffusion resistance at low CO2 to CH4 ratio, while the influence became weaker at higher CO2 to CH4 ratio. An additional peak, with a larger relaxation time of 10(-1)similar to 10(1) s, was observed with dry reforming gas mixtures. This process, related to dry reforming reaction and water-gas shift reaction, was also influenced by the addition of CO2. Besides, we observed an improvement of fuel cell performance by adding appropriate N-2 carrier gas to fuel gas, which may provide a new way to enhance the performance and durability of biogas-fueled SOFC.

Performance Evaluation of Solid Oxide Fuel Cell with In-Situ Methane Reforming

Direct carbon dioxide-methane solid oxide fuel cells combined with in-situ exsolution perovskite La0.75Sr0.25Cr0.5Fe0.4Cu0.1O3-δ-based dry reforming catalysts

Applying high efficiency internal reforming catalyst for direct low concentration coal mine methane solid oxide fuel cells

Enhanced electrochemical performance and durability for direct CH4–CO2 solid oxide fuel cells with an on-cell reforming layer

Electrochemical Characteristics and Carbon Tolerance of Solid Oxide Fuel Cells with Direct Internal Dry Reforming of Methane

LaMnO3-Type Perovskite Nanofibers as Effective Catalysts for On-Cell CH4 Reforming via Solid Oxide Fuel Cells

Co-Generation of Electricity and Chemicals via Solid Oxide Fuel Cells Using Li-Doped LSGM and LSF Composite Anodes

Power generation via solid oxide fuel cell using ex-reformed oxygen-containing low-concentration methane

Direct carbon dioxide-methane solid oxide fuel cells integrated for high-efficiency power generation with La0.75Sr0.25Cr0.5Fe0.4Ni0.1O3–δ-based dry reforming catalyst

Performance of solid-oxide fuel cells operating with different sustainable fuel reformates

A Robust Flat-Chip Solid Oxide Fuel Cell Coupled with Catalytic Partial Oxidation of Methane

Optimization of Methane Reforming for High Efficiency and Stable Operation of SOFC Stacks

Enhanced conversion efficiency and coking resistance of solid oxide fuel cells with vertical-microchannel anode fueled in CO2 assisted low-concentration coal-bed methane

Direct Operation of Solid Oxide Fuel Cells on Low-Concentration Oxygen-Bearing Coal-Bed Methane with High Stability

Anode Performance of Mn-doped Ceria–scsz for Solid Oxide Fuel Cell

A review on anode on-cell catalyst reforming layer for direct methane solid oxide fuel cells

Co-Generation of Electricity and Syngas on Proton-Conducting Solid Oxide Fuel Cell with A Perovskite Layer As A Precursor of A Highly Efficient Reforming Catalyst

In-situ Analysis of Anode Atmosphere in a Flat-Tube Solid Oxide Fuel Cell Operated with Dry Reforming of Methane

Direct liquid methanol-fueled solid oxide fuel cell

Autothermal reforming of methane over an integrated solid oxide fuel cell reactor for power and syngas co-generation

High Performance Tubular Solid Oxide Fuel Cells With Bscf Cathode