Abstract:As process technologies advance into deep sub-micrometer and nanometer scale, the charged device model (CDM) is now considered an important stress model for defining electrostatic discharge (ESD) reliability of integrated circuits. Thus the turn-on time of the ESD elements used in the protection circuit becomes important. At this time, there is no good method to evaluate the CDM ESD device turn-on speed. Equipment like VF-TLP and CC-TLP are too complicated and not precise for this purpose. A new method to evaluate the ESD device turn-on speed is presented in this paper. Based on this novel approach, some CDM ESD devices are analyzed based on the transmission line pulsing (TLP) tester. The designed devices include diodes, grounded-gate NMOS, SCRpsilas (silicon controlled rectifier), and Modified-Lateral SCRpsilas (MLSCR). The rising time of the pulse is set at 200 psec to accurately simulate real CDM pulses. The time-dependent voltage and current data are extracted and calculated from each pulse in the Time Domain Reflection (TDR) TLP tester. Two new ESD turn-on conditions are proposed and defined based on the transient currents in order to compare the relative speed of different ESD devices. The results show that the normalized turn-on time of different devices with various sizes and finger numbers do not correlate well with that obtained under the normal DC conditions, and the same device shows different turn-on characteristics under different pulses. These results enable devices to be designed for improved CDM ESD protection levels, and the present method can be used for ESD design for future nanometer technologies.

Design Optimization of High Voltage NPN ESD Protection Device in 130nm Power SOI Technology

Analysis of 65 Nm Technology Grounded-Gate NMOS for On-Chip ESD Protection Applications

Electro-Thermo-Mechanical Investigation On Multi-Level Interconnects In The Presence Of An Esd Pulse

Silicon-Validated Power Delivery Modeling and Analysis on a 32-Nm DDR I/O Interface.

Investigation of Esd Protection Strategy in High Voltage Bipolar-Cmos-Dmos Process

Design Analysis of Novel Substrate-Triggered GGNMOS in 65nm CMOS Process

Design and Analysis of an Area-Efficient High Holding Voltage ESD Protection Device

A Novel Substrate-Optimized GGNMOS for Low-Voltage ESD Protection in 65 nm CMOS Process

An Overview of ESD Protection in Nanometer IC

On the ESD Protection and Non-Fatal ESD Strike on Nano CMOS Devices

Effects of process variation on turn-on voltages of a multi-finger gate-coupled NMOS ESD protection device

Design Analysis of a Novel Low Triggering Voltage Dual Direction SCR ESD Device in 0. 18μm Mixed Mode RFCMOS Technology

Investigation on Bi-directional SCR ESD Protection Devices in a 0.18 μm RF CMOS Process

Evaluation of RF electrostatic discharge (ESD) protection in 0.18-μm CMOS technology

A Systematic Study of ESD Protection Co-Design with High-Speed and High-Frequency ICs in 28 Nm CMOS.

FOD Based ESD Protection Devices in Deep Sub-micron Technology

Ggnmos As Esd Protection in Different Nanometer Cmos Process

Investigation of Turn-on Speeds of Electrostatic Discharge Protection Devices Using Transmission-Line Pulsing Technique

A Robust Scalable ESD Protection Device integrating Drain side Floating P+ Diffusion with tunable ESD Design Window and effective Latch-up immunity for High-Voltage Power Clamp applications

New Electrostatic Discharge Protection Device for VBO High Speed Chip

Optimization On Layout Strategy Of Gate-Grounded Nmos For On-Chip Esd Protection In A 65-Nm Cmos Process