Abstract:The effect of Ar pressure on the performance of W/Si rnultilayers is investigated. W/Si multilayers were deposited by a high vacuum DC magnetron sputtering system. The Ar pressure was changed from 1.0 to 5.0 mTorr with an interval of 1.0 mTorr during the deposition process. Electron probe microanalysis and Rutherford backscattering are performed to determine the Ar content incorporated within these multilayers. The results demonstrate that less Ar is incorporated within the sample when more Ar is used in the plasma, which could be explained by the increase of the collision probability and the decrease in the kinetic energy of Ar ions arriving at the substrate when more Ar exists. The grazing incident X-ray reflectivity (GIXR) at 0.154 nm is used to determine the structural parameters of the layers. The results show that the structures of these multilayers prepared at different Ar pressure are very similar and that the interface roughness increases quickly when the Ar pressure is higher than 3.0 mTorr. The measurements of the extreme ultraviolet (EUV) reflectivity indicate that the reflectivity decreases when Ar pressure increases. The fitting results of GIXR and EUV reflectivity curves indicate that with an increase of Ar pressure, the density and decrement of the refractive index are increased for W and decreased for Si, which is mainly due to (1) the decrease in Ar content incorporated within these multilayers which affects their performance and (2) the increase of collision probability for sputtered W and Si, the decrease of their average kinetic energy arriving at the substrate, and thus the loosing of their layers.

Periodic Variation of Stress in Sputter Deposited Si/WSi2 Multilayers

Stress in Amorphous Siox:H Films Prepared by Plasma-Enhanced Chemical Vapor Deposition

Pressure-dependent transition from atoms to nanoparticles in magnetron sputtering: Effect on WSi2 film roughness and stress

Stress relaxation in Mo/Si multilayer structures

Stress and Microstructure Study of W/Si X-ray Multilayers with Different Structural Parameters.

Study of Local Stress Using Stress-Absorbing Si Diaphragm

Stress Analysis of Mo, MoSi 2 and Si Mono-Layer Thin Films and Multilayers Prepared by Magnetron Sputtering

Study on the Mechanism and Measurement of Stress of Tio2 and Sio2 Thin-Films

Stress-Induced Wrinkling of Sputtered Sio2 Films on Polymethylmethacrylate

Strained Layer Instabilities on Vicinal Surfaces: Ge0.8Si0.2 Epitaxy on Laser Textured Si(001)

Asymmetric Interface and Growth Mechanism in Sputtered W/Si and WSi2/Si Multilayers

Substrate-Induced Stress In Silicon Nanocrystal/Sio2 Multilayer Structures

Influence Of Working Gas Pressure On The Performance Of W/Si Multilayers

Structure and Stress Studies of Low Temperature Annealed W/Si Multilayers for the X-ray Telescope

Structure and stress properties of W/Si multilayers with different background pressure and working pressure

Effects of sputtering parameters and separator plates on the structure and stress of W/Si multilayers in x-ray telescope applications

Stress Measurement At The Interface Between A Si Substrate And Diamond-Like Carbon/Cr/W Films By The Electronic Backscatter Diffraction Method

Improvement of Stresses in Multilayer Structures with SiO/sub 2//pt/pb(zr,ti)o/sub 3//pt Thin-Film Stacks for Micro-Scanner Actuators

An Investigation of the Effect of Interfacial Atomic Potential on the Stress Transition in Thin Films

Residual Stress Study of SiO2/Pt/Pb(Zr,Ti)O3/Pt Multilayer Structure for Micro Electro Mechanical System Applications

Observation of Systematic Deviations of Period in W/Si and W/C Multilayers