Optimizing Annealing Process for Ferroelectric Y‐Doped HfO 2 Thin Films by All‐Inorganic Aqueous Precursor Solution

Jingjing Wang,Dayu Zhou,Wei Dong,Yifan Yao,Nana Sun,Faizan Ali,Xiaoduo Hou,Feng Liu
DOI: https://doi.org/10.1002/aelm.202000585
IF: 6.2
2021-01-06
Advanced Electronic Materials
Abstract:<p>10 nm thick yttrium doped HfO<sub>2</sub> (Y:HfO<sub>2</sub>) thin films are prepared on Si (100) substrates by the chemical solution deposition method using all‐inorganic aqueous salt precursors. The influence of the annealing process, consisting of annealing temperature, holding time, and heating rate, on the crystalline structure and ferroelectric properties of thin films is investigated. Results show that the crystalline structure and ferroelectric properties of films exhibit a strong annealing process dependence. The monoclinic phase and asymmetric orthorhombic phase coexist in the films. The annealing process of the best ferroelectric behavior is obtained by using annealing temperature at 700 °C for 30 s with a heating rate of 30 °C s<sup>−1</sup> in N<sub>2</sub> atmosphere. The film exhibits lowest m‐phase fraction of 17.9%, accompanied with the highest remanent polarization of 21.4 µC cm<sup>−2</sup>.</p>
materials science, multidisciplinary,physics, applied,nanoscience & nanotechnology
What problem does this paper attempt to address?
The aim of this paper is to optimize the annealing process of yttrium-doped hafnium oxide (Y-doped HfO2) thin films to improve their ferroelectric properties. Specifically, the study focuses on the effects of annealing temperature, holding time, and heating rate on the crystal structure and ferroelectric properties of the films. Y-doped HfO2 thin films were prepared by chemical solution deposition, and the impact of different annealing conditions on the coexistence of the monoclinic phase and orthorhombic phase in the films was investigated. The ultimate goal is to find the optimal annealing conditions to obtain ferroelectric films with high remanent polarization. The study found that under a nitrogen atmosphere, annealing at 700°C for 30 seconds with a heating rate of 30°C/s resulted in the lowest monoclinic phase fraction (17.9%) and the highest remanent polarization (21.4 µC/cm²). This result is not only applicable to Y-doped HfO2 thin films but also provides guidance for other doped perovskite-type ferroelectric materials.